Question about 2005 Dodge Grand Caravan

Open Question

2005 grand caravan 3.3 l. 157 K mile. Feeling jacked or number 6 not working replaced feel injectors and wiring Pigtail. New plugs new wires now car won't start. No power to Injectors. Help

Posted by on

Ad

6 Suggested Answers

Anonymous

SOURCE:

Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017

Ad

Smarterer

  • 170 Answers

SOURCE: Kia Sorento misfiring after replacing timing belt and (6) plugs

Tell the garage to install the same spark plugs, as the ones KIA uses. I've seen many cars have missfiring because the wrong spark plugs are used. The worst plugs for causing missfiring are Bosch Platinum. Have the garage change the oil too, as it's now contaminated by unburnt petrol.

Posted on Aug 20, 2009

Ad

Anonymous

  • 71 Answers

SOURCE: ENGINE LIGHT FLASHING...CAR MISFIRING...INSTALLED

the flashing light indicates to the driver that the engine is under severe misfire wich could lead to damaging the cat. Have the codes pulled by autozone or advance they do it for free. Then start there but it sounds like it could be your oxygen sensor

Posted on Apr 26, 2010

pctech1

Jeremy Moore

  • 1940 Answers

SOURCE: Number one cylinder misfiring.

Check and replace your timing belt, although it is probably not the culprit, I have seen a tooth missing from a worn timing belt cause misfiring.

It is probably the Crankshaft Position Sensor, or the Camshaft Position Sensor causing the misfire.


I’m happy to help further over the phone at https://www.6ya.com/expert/jeremy_69f3cc28d95bf514

Posted on Jul 10, 2010

Anonymous

  • 4 Answers

SOURCE: Would A 2006 Chevy Equinox with just 40,000 miles

Possibly. It depends on what the climate is like where you live. For instance, if you live in an area where the summer climate hits 110 (i.e. Phoenix), then your vehicle will need to be serviced more regularly. Best recommendation, take your vehicle to AutoZone, Checkers, O'Reillys, etc. for a free diagnostic check.

Posted on Jul 28, 2010

dttech

dttech

  • 4803 Answers

SOURCE: 2005 dodge grand caravan 3.8L

Ouch! A case of the raucous rodent! I've been there...Not fun trying to track down and repair all the damage.

First of all, let me explain how the code sets: The computer monitors the PRIMARY side of the coil to determine the burn time on the SECONDARY side of the coil. This can be a little confusing. The code will set when the computer determines that secondary ionization (burn time) was too short, too long, or did not occur at all.
If you have confirmed that there is no spark at the spark plug wires, then that is why the code is setting...ionization is not occurring at all. What can be a little confusing is that this can be caused by a failure in the PRIMARY coil circuit even though the code is indicating that the computer is having a problem with the SECONDARY circuit. (The secondary circuit can malfunction even though the primary side is functioning perfectly, but if the primary side malfunctions, the secondary side ALSO malfunctions - it is impossible for the secondary side to work if the primary side is not working.)

So, I said all that to tell you this: I think you have pretty much eliminated the entire secondary side of the ignition by replacing the whole circuit. So the problem must be on the primary side. (Probably more chewed wires)
There are 4 wires going to your ignition coil. The BROWN/WHITE wire comes from the ASD RElay and supplies battery voltage to the coil assembly. Since the other four cylinders are firing, This wire has to be OK.
The code you are getting is for coil #2. This coil is controlled by computer through the DARK BLUE/TAN wire. If you disconnect your coil connector and probe this wire with a test light connected to the POSITIVE battery post, it should "blink" when to crank the engine over. My guess is that it will not be blinking. You can do this also on the BROWN/ORANGE (coil #1) wire and the DARK BLUE/DARK GREEN (coil #3) wire to see the difference.

Anyway, if the DARK BLUE/TAN wire does not blink, then the wire is broken (chewed?) between the coil and the PCM.

Posted on May 08, 2011

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

I have a 2003 s10 blazer 4.3v6 vortec. ok i keep getting hydrolock my #6 keeps feeling up with gas. i changed the sensors bought one new injector and new regulator and still the same.New pcm?


# 6 injector ground side is shorted to ground causing injector to fire constantly . It's probably not the PCM , If injector driver inside the PCM was bad the injector wouldn't fire at all . On the injector there are two wires , one is B+ voltage , the other goes to the PCM . PCM supply's a ground when triggered . How to test fuel injector circuit with basic tools open control wire

Jan 26, 2017 | 2003 Chevrolet Blazer

2 Answers

I have a miss in 3rd cylinder.


suggest you check the distributor cap & especially the spark plug wire of the 3rd cylinder

Sep 22, 2015 | 1993 Nissan Sentra 4 Door

1 Answer

#1 cylinder is not firing. Coil is working as I switched it with another cylinder. Fuel injector is new. Mice chewed the two injector wires at the clip to the injector. They were pressed together. Can


Have you tried replacing the plug on that cylinder ? Might be bad . Also I would replace the wire to the injector that the mice ate. Could be damaged in more then one place.

Jan 26, 2015 | 2005 Scion xB

1 Answer

I have a 2005 grand caravan v6 3.3L cylinder 5


check the operation of the fuel injector and for a vacuum leak were the intake fastens to the head and compression on this cylinder.

Sep 09, 2014 | 2005 Dodge Grand Caravan

1 Answer

Miss fire at cylinder 6 on my 2004 grand am 3.4 i have replaced new plug new coil and wire whats next still miss fires


With the engine running and the cylinder misfiring tap (key word is tap) the injector with a screwdriver a couple of times. If the misfire goes away replace the injector.

I’m happy to assist further over the phone at https://www.6ya.com/expert/jeremy_d728a59f986299fa

Nov 29, 2012 | Cars & Trucks

1 Answer

2005 3.3 litre grand caravan has a miiss and service engine light is on


A miss in the engine could be several things, but the most common is a bad spark plug wire or boot. You can check each wire for bad spots, but a trick I use is a dark garage with the car running. Use a pair of leather gloves to move the wires around, because 30,000 volts hurts! Any glowing blue is a "leaking" wire, and you may even have a shorted wire that throws tiny bolts of lightning. Replace all of the wires with a good quality set. A good set of spark pugs at the same time is also a good idea because a bad wire will ruin the plug. And yes, a bad plug or wire will turn on the check engine light because it trips the knock sensor and O2 sensors. The other common miss problem is bad fuel and or plugged injectors. Try a fuel system cleaner.

Mar 14, 2011 | 2005 Dodge Grand Caravan

2 Answers

I have code po306 misfire in 6 cylinder. The plugs,wires, and oxygen sensor in bank 2 replaced. The check engine light is flashing on and off. NO codes for the catalytic converter. Just one code for the...


code p 0306 is misfire on no 6 cylinder
normally not anything else beside problem injector or injector wiring
remove and clean that injector then use a quality injector cleaner in tyhe tank to clean the rest

Sep 16, 2017 | Ford Taurus Cars & Trucks

2 Answers

2005 dodge grand caravan misfiring and sluggish after replacing spark plugs and wires and cleaning throttle body. PCM was just changed and programmed.


2005 CARAVAN 3.3L.
Van misfires, code says coil three . change out with new a cam sensor , injector, wires , plugs and of coarse coil. What is left and why would the pcm just have a problem with # 3.
ps i checked the compression and all six cylinders have 165. lbs.

Feb 18, 2010 | 2005 Dodge Grand Caravan

3 Answers

99 dodge caravan #4 cylinder misfires, i replaced spark plug wires and spark plugs. Scanner showed #4 still misfiring, could this be the coil?


It could very well be a bad coil pack,or you have low compression in that cylinder.If the compression is good then go with the coil pack,if not you may need a head gasket or an intake manifold gasket.

Nov 07, 2009 | 1999 Dodge Grand Caravan

Not finding what you are looking for?
2005 Dodge Grand Caravan Logo

Related Topics:

35 people viewed this question

Ask a Question

Usually answered in minutes!

Top Dodge Experts

Marvin
Marvin

Level 3 Expert

85223 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22485 Answers

Jonah Oneal

Level 3 Expert

14092 Answers

Are you a Dodge Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...