At Fixya.com, our trusted experts are meticulously vetted and possess extensive experience in their respective fields. Backed by a community of knowledgeable professionals, our platform ensures that the solutions provided are thoroughly researched and validated.
Re: How to set rocker arms on 1995 jeep cherokee 2.5
The rockers on the 2.5 motor are hydraulic lifters.They cant be adjusted.If there is a noisy lifter it may be a different problem.What's happening?Hope this helps
- If you need clarification, ask it in the comment box above.
- Better answers use proper spelling and grammar.
- Provide details, support with references or personal experience.
Tell us some more! Your answer needs to include more details to help people.You can't post answers that contain an email address.Please enter a valid email address.The email address entered is already associated to an account.Login to postPlease use English characters only.
Tip: The max point reward for answering a question is 15.
its in the FSM. want to read that for free.
see chapter marked ENGINE>
chapter 9
ZJ jeep it is.
there is no such thing,
sorry
here ill paste the install push rods/rockers. lines
(1) Rotate the crankshaft until the "V8" mark lines
up with the TDC mark on the timing chain case
cover. This mark is located 147° ATDC from the No.1
firing position.
(2) Install the push rods in the same order as
removed.
(3) Install rocker arm and pivot assemblies in the
same order as removed. Tighten the rocker arm bolts
to 28 N·m (21 ft. lbs.) torque.
CAUTION: DO NOT rotate or crank the engine during
or immediately after rocker arm installation.
Allow the hydraulic roller tappets adequate time to
bleed down (about 5 minutes).
(4) Install cylinder head cover.
(5) Connect spark plug wires.
end. quote.
Carefully remove the entire rocker assembly then replace the broken or worn individual rocker arm and reassemble..can be obtained at any Chrysler/Jeep Dealership...Ur Velcum
assuming you have a 4.0 liter 6 cyl in the truck the answer is no, no valve adjustment is required. there should be 2 rockers held down by 1 bridge ans 2 bolts, those bolts need to be tightened to 16-26 foot pounds.
please respond
Remove the valve covers. Inspect each rocker arm for wear, cracks or other damage, check the rocker arm abd dykcrum for wear, replace with new ones, they can"t be adjusted.
You have hydraulic lifters which are not adjustable. Torque setting for rocker bridges is 19 foot lbs. If valvetrain is noisy, lifters or cam need replacement, unless rocker pivots are visibly worn.
×