2001 saturn no power to fuel punp - Saturn Cars & Trucks

This may depend on your vin? Did you use a test light to see if terminal 30 is hot? My database showed two vins, I need to know which one?

Are you sure your car has a fuel punp reset button in the trunk? Mine has not! Not all cars has fuel punp reset button in the trunk

- Missing or loose fuel cap
- Incorrect fuel filler cap used
- Fuel filler cap remains open or fails to close
- Foreign matter caught in fuel filler cap
- EVAP canister or fuel tank leaks
- EVAP system hose leaking
- Fuel tank leaking

Sounds like a spark problem, such as a cam/crank sensor, coil pack etc.

If it turns over when you turn the ignition key and you have power. Check too see if it is getting gas. The fuel pump could not have enough pressure to start the engine. When you first turn you key on listen and see if you hear the pump runs for a couple of seconds. If no sound probably fuel pump. Do a pressure test first.

check the fuel pressure on the new fuel punp check the fuel punp relay

No but there is a fuel pump relay. If there is power at the relay and no power at the pump replace the relay. It is fairly easy to check Where the relay is are others that are the same, switch two relays and see if the other item works.

It is a common failure item on these cars. That is to say the fuel pump itself. You still want to check the connection back at the tank for power before you repalce the punp. It is not cheap, but check on EBAY if you need one. I just bought a complete assembly for a Tahoe that was only 80 with shipping compared to over 300 at autozone.

Hope this helps

when you stared it does it started and then shut off if it does check you fuel filter and you mafs ok and all your wireing

Sorry the saturn's do not have a inertia switch. But more information would help. Like does the security light activate on the dash, you may have a bad Passlock, Place the ignition key to the on possition for 10 min and then try starting it. 
Good luck and let me know how things are going. There should be instructions in your manual on how to get the car started if the Passlock is giving you problem.

you have a voltage drop problem probably a coroded wire if you can open wire harness and do voltage checks down the wire until you find the bad spot and repair or you can run a bypass wire