I mean the 3 bars that go by the motor underneath the hood that makes the gears work.
SOURCE: power window not working, motor and electric good, whats wrong?
Well either the gears aunt lined up correctly or the motor old and tired. Doesn't have enough power/torque to spin gears. might just need a new motor.
SOURCE: starter motor peugeot 106
aveu tried puting car in gear and just rocking it bath and forward
SOURCE: transmission passing gear keep either getting
this could be relative to many things, however you should check a few things before asessing the possibilities. When you put the truck in gear from park, Drive (overdrive) Should be the third notch you come to. so your in park, pull down clunk you're in reverse, clunk you're in neutral, clunk, now you are in drive. If you dont feel/ hear four notches/ clunks, you should be in overdrive. If you take off and it over revs 1st ( you shouldn't see more than 15 mph before it shifts on a stock transmission unless your flooring it and taking off fast) and then hard shifts to second gear, progresses to third gear normally, but wont progress into overdrive, it may be related to your vaccum advance, your shift linkage, or even possibly your timing. From the sounds of it, I would say vaccum advance is the likely cause, if it is otherwise in stock condition. If this is the case it could be as simple as reconnecting a vacum hose to the distributor. Should be to the left hand side of the cap, between the cap and intake manifold as you are looking at the firewall.
SOURCE: gears stick
If your car is a manual gear change, your clutch may need adjusting or repair or the gearbox oil may need changing.
If your car is an auto check to see if you are using the correct transmission fluid , Peugeot autos do not use normal ATF and will fail if the correct fluid is not used.
Hope this helps Marshall
72 views
Usually answered in minutes!
×