2000 Nissan Quest Logo

Related Topics:

June Kennedy-Elkin Posted on Sep 17, 2019
Answered by a Fixya Expert

Trustworthy Expert Solutions

At Fixya.com, our trusted experts are meticulously vetted and possess extensive experience in their respective fields. Backed by a community of knowledgeable professionals, our platform ensures that the solutions provided are thoroughly researched and validated.

View Our Top Experts

2000 nission quest bulbs wont stay in headlights

What to replace

1 Answer

Sam Akber

Level 3:

An expert who has achieved level 3 by getting 1000 points

All-Star:

An expert that got 10 achievements.

MVP:

An expert that got 5 achievements.

Genius:

An expert who has answered 1,000 questions.

  • Nissan Master 1,149 Answers
  • Posted on Sep 18, 2019
Sam Akber
Nissan Master
Level 3:

An expert who has achieved level 3 by getting 1000 points

All-Star:

An expert that got 10 achievements.

MVP:

An expert that got 5 achievements.

Genius:

An expert who has answered 1,000 questions.

Joined: Feb 25, 2011
Answers
1149
Questions
0
Helped
330127
Points
3323

If they are the correct bulbs then the holders in the headlight are mealted with the heat, sorry if that is the case, you may need to replace the headlights.

5 Related Answers

Anonymous

  • 491 Answers
  • Posted on Oct 11, 2008

SOURCE: replace headlight bulb

inside the engine compartment directly behind the headlight it unscrews and pops out. then put it back in and retighten.

Ad

Anonymous

  • 275 Answers
  • Posted on Nov 12, 2008

SOURCE: headlight bulb replacement

it should come out of the back of the housing just turn it one way or the other and pull it out or there is a keeper holding it in

Anonymous

  • 19 Answers
  • Posted on Feb 01, 2009

SOURCE: how to remove headlight to change bulb on 2000 beetle?

On the side of the headlight assembly there is a lever sticking out with a checkered section just above it you have to push the checkered part (it's the release for the mechanism) then lift it up and slide it forward, but be ready to catch it when it slides out. Next remove the connectors on the back and pull it all the way out. I usually set it on a towel or something so it wont roll around while working on it. Getting it back in is trickier though because you have to line the tracks up perfectly when you slide it in otherwise it'll bind up on you. If you search the DIY on vwvortex there's a pile of good info to make your life easier.

Anonymous

  • 187 Answers
  • Posted on May 07, 2009

SOURCE: Need to replace the bulb on 2000 grand am gt

You should be able to replace the bulb from the rear of the light from inside the engine compartment. I is a small bulb unlike the hole light as in older cars. You must pull the plug connector off the back of the bulb than un-clip the heavy wire spring retainer and pull the bulb back. Try to remember the position of the metal positioning tabs. It's not a bad idea to take it with you when you go to buy a replacement as well as the car info. The new bulb must be handled with extreme care. At no time can you touch the glass bulb part. The oils from you had will significantly reduce the bulbs life. Now just slide the bulb back into the hole noting that there are three tabs of different size to insure the proper position of the bulb to get the correct light pattern on the road. Good luck.

Anonymous

  • 109 Answers
  • Posted on May 17, 2009

SOURCE: after turning ignition, only parking lights work. low beam headlights were replaced recently. parking lights wont even turn off. headlights

I had an S-70 with the same problem what happens is the headlight switch tabs that hol it together broke and the switch was slightly separated and connection was not there for the headlights and also check the high beam see if headlights come on i dont think it is a relay or fuse??? proballally the headlight switch and easy to replace you even can use one from an 850 model

Ad

Add Your Answer

×

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

0helpful
1answer

Where is the right headlamp relay located on a 1999 nissan quest

There is no headland rely.
The bulb is connect to the headlight switch then to the battery.

Take the right head light off and set your DMM to ohm to check the resistance of the low beam.
Open reading = bad bulb (MOST LIKELY CASE)
close reading = bad contact,switch or wiring (NO LIKELY)
0helpful
1answer

Headlights

I would suspect the bulb is at fault or the connector to the bulb, but you don't say the type of headlights you have so that handicaps my diagnosis. As for aftermarket so called high intensity bulbs I would stay away from them.
0helpful
1answer

I have a 2000 maxima...when headlights are on, passenger side blinker stays lit on the dash and doesn't flash at all. While the headlights are off and i turn the passenger turn signal on it then b

Plain and simple...Your turn signal circuit is shorted to your headlamp circuit. What USUALLY causes this is an incorrect light bulb has been installed in the vehicle or the light bulb was installed incorrectly. There are other possible causes of these circuits being shorted together, but 99 out of 100 of the times that I have seen this it is either because somebody just replaced a bulb or a bulb socket melted somwhere on the car. Be sure to check both the front AND rear bulbs.
0helpful
1answer
0helpful
1answer

One headlite goes out in less than a min. then stays out. The same side fog lite was knocked out recently and has not been replaced. How can I make the headlite stay on?

sounds like the fog light is shorting out the system, and if its on the same side as the headlight, the filament in the bulb could h ave received damage also check the connections on each light, and also check the bulbs with a meter
0helpful
1answer

How do you replace low beam headlight on a 2006 nissan quest? passager side

if you mean the headlight bulb then iam afraid its a bumper off job ,no quick way on modern cars as no access
0helpful
1answer

Passenger side headlight works but driver side doesnt checked the bulb and replaced the plug

check the box under the hood drivers side by the strut tower has two conecters, the pc board may have bad solder joints,resolder the joints where the conectors are
0helpful
1answer

I have a problem with my 2000 nission truck can u

when you turn the key do you hear a click (behind the firewall), but the starter would not do anything, then the problem is with battery. Sounds like you aren't pulling enough juice from the battery. Check the water level in the cells and do a load test.
Try replacing the starter also.
ifthat doesn't do it, check to ensure that you have a good ground on the firewall and check the connections to the solenoid.
0helpful
1answer

How do I replace the headlight assembly on a 2002 nissan quest?

There should be a three wire connector at the headlight. Disconnect it. Turn the large plastic nut that holds the bulb in place and replace the bulb.
1helpful
1answer

Passenger side headlamp wont light up

I'm assuming globe means bulb. I have replaced many bulbs that look fine, and that turns out to be the problem. But to stop you from chasing down a problem that isn't there, test the connector that attaches to the bulb. Should be power there with the head lights on. There should be a fuse, and a relay. The fuse is under the dash or on the side of the dash near the door hinges, I'm just not sure if this car would have seperate fuses for L headlight and R headlight. But you should check power first at the connector.
Not finding what you are looking for?

70 views

Ask a Question

Usually answered in minutes!

Top Nissan Experts

ZJ Limited
ZJ Limited

Level 3 Expert

17989 Answers

Thomas Perkins
Thomas Perkins

Level 3 Expert

15088 Answers

Arnie Burke
Arnie Burke

Level 3 Expert

7339 Answers

Are you a Nissan Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...