I have a 2014 Peterbuilt 386, truck has 460,000 miles on it, Truck is down, Bill is already at $10,000, can I get ploicy help on this Truck, on the edge of losing my Business, looking for help!

SOURCE: 1998 chevy K1500 timing runs ok for 10 miles then loses all pwr

1-timing on truck is ajusted by ecm,when u moved it u cause cam sensor code because it detected timing was off! 2-o2 sensors has the role of detecting air to fuel ratio coming out of exhaust,sends signal to ecm wich collects data from other sensors from that sets timing for best performance,if ecm detects something wrong in system data it will give engine code,that code will point at problem area,in your case o2 sensors probably detected lean fuel ratio that points to fuel system,blocked fuel filter or fuel pump faillure,elect,circuit damage,hope it helped!

SOURCE: 1995 nissan pickup truck fuel problem

Fuel injected or carb? Make sure fuel line itself is clear. Some pumps are designed to self regulate (carb systems) some continually pump and a psi regulator sends back the excess fuel back to the tank (fuel inj systems) If the line is obstructed then pump can't deliver fuel fulltime.

If you think pump is not on consistent, try running a dedicated wire through a switch directly to the pump. If it works then you are looking for an electrical fault going to pump. Good luck.

SOURCE: truck is not getting gas will not accelerate over 10 miles per

I think it may be coincidence and you have a fuel pump that has failed. Have the fuel pressure tested and replace the pump and filter as is necessary.

SOURCE: Wat is connect service tool code on 2014

Obd2

SOURCE: 2005 GMC Yukon Denali's computer shuts down after the truck warms up

sounds like a fuel problem, how many miles on vehicle? as a quick fix it would be worth using a fuel addative , you haven't said if petrol or diesel, if petrol get addative that covers the catalytic converter ,having a blocked exhaust system can cause engine to stall also get the OBD codes read as this will tell you what if any sensors/switch's are faulty