SOURCE: rear disc pistons, are they wind in? on a renault trafic van
these are a bastard, yes they are wind in. i have the proper tool, £300 this struggles, a cheap £60 sealey pisses the job. they have to turn and push at same time. tricky junk job. have fun.
SOURCE: brake pad wear warning light on after new pads
why doese the pad wear sensor light stay on after fitting new pads and sensor
SOURCE: change hyundai accent 2001 front brake pads
Once the car is jacked up, remove the front tires, then whith a 12 wrench key, remove the bolt that is located on the rear side of the caliper, not the one holding the brake fluid line buth the one right next to it. Pry the brake pad holder off and then remove the brake pads themselves. You will need to press the caliper's piston in, to be able to fit new brake pads since new pads will be thicker.
SOURCE: Replacing lincoln LS rear brake
Screw in rear caliper pistons. Install pads and caliper,then ratchet up parking brake by hand, at caliper. No electric or cable issues involved
SOURCE: Renault clio abs light comes on with vibration
How hard are you stepping on the brake pedal? What you are describing sounds like the ABS system activating. When you step on the pedal hard enough to engage the ABS the light will come on, in some cars it will blink. You will also feel the thumping/vibration in the pedal since the system works by repeatedly engaging and disengaging the brakes. If it is happening when you step lightly on the brakes then you may have a bad wheel speed sensor or possibly a bad or miss-adjusted brake switch.
108 views
Usually answered in minutes!
×