There isn't one. Cruise Control is a joint computer operation by the BCM and ECM.
Mercury Villager (1999-2002) fuses and relays
Fuse Box Diagrams
https://fuse-box.info > mercury > mercury-villager-19...
Here you will find fuse box diagrams of Mercury Villager 1999, 2000, 2001 and 2002, get information about the location of the fuse panels inside the car, ...
https://www.google.com/search?q=mobile+auto+electrician+near+me
..
SOURCE: Rear seat removal 2000 merc Villager
fold top seat down first
then there is seat clip push seat forward with upward motion
this releases back floor clamps once released pull seat back this releases the front clamps then pull seat out of back door
SOURCE: fuse location for cruise control on a 2000 dodge caravan
The cruise has no dedicated fuse, you will most likely be looking to replace the clockspring rotating contact located under the steering wheel which connects the switches in the steering wheel (horn, cruise and air-bag) to the rest of the electrical system.
SOURCE: where is a knock sensor for 1998 Mercury Villager located?
Here is a image of it's location, I hope it helps.
SOURCE: where is a knock sensor for 2000 mercury villager
It is under the lower intake manifold in the valley of the engine.You must remove the cross over coolant tube to gain access to the knock sensor. It bolts into the cylinder head. Good luck
Testimonial: "good help, thanks."
SOURCE: looking for location of crankshaft position sensor
The 3.3/3.8L crankshaft sensor is located on the rear of the transmission housing, above the differential housing The bottom of the sensor is positioned next to the drive plate. Remove the 10mm bolt holding the sensor in place and remove the sensor. Install the new crankshaft sensor.
Install crankshaft sensor bolt and tighten. Connect wiring. merry christmas !!
225 views
Usually answered in minutes!
×