SOURCE: removing a discovery 1 head rest the handle type
The headrest is hold by the two bars of the middle. The bars are engaged in two plastic guides fitted in the seat frame. The bars are locked by two little springs located in theses guides. They are very difficult to remove under the seat foam. The solution I used is a hammer (quite heavy) with a T bar from a sockets set . The diameter was exactly the same as the inner diameter of the plastic guide . Then I inserted this bar at the bottom end of the plastic guides and I hit the bottom of the mettalic bars with these tools and I managed. After the inspection, the springs were bended and I had to give the former shape they had before the removal.
Good luck ( sorry for my poor english but I'm french!)
SOURCE: Need to remove head rest to put on seat covers
I looked into new headrest for my 2005 Grand Cherokee with the monitors installed in them. I had mine off but couldn't remember how i did it. But I got the instuctions from the the company with the new headrest and they linked me to a video online. The company was on ebay. I remember that it was really simple
SOURCE: 2009 toyota rav4 rear headrests
You can pry them back and they should tilt. Otherwise pull up real hard and they will come out.
SOURCE: How do we take the head rest off the Silverado
push the plastic clip in towards the metal support bar
SOURCE: How to remove the head rest from the driver's seat 05 sunfire
There should be tiny holes in the plastic covers at the base of the chrome rods attached to the headrest use a paper clip and push it in the holes as you pull on the headrest in the full up postion.
288 views
Usually answered in minutes!
×