Here is a post that will give you an idea on how the system works and how to repair it.
https://repairpal.com/car-wont-start-because-of-anti-theft-system-that-uses-raised-chip-key-033
SOURCE: 1988 buick la sabre trouble codes
code 23 is mat sensor signal low wich is the manifold temperatur sensor return valtage is low to the computer. check for a sensor that is on the air cleaner housing that has two wires on it. the connector on the sensor is grey in color. if it's not unplugged replace it.
the code 34 is for the map sensor wich is located on top of the engine. but if you have a bad map sensor you would be writing in for a rough running car or something.
was someone unplugging stuf when this thing was running at one time? - good luck
SOURCE: windows wont go up and down
Hi
I had the same problem with my 2001 LeSabre rear window. Use a small paint scraper to gently pry the door panel in the area of the plastic buttons. Remove the plastic cover surrounding the door handle and there will be a screw to remove. The door panel should now be able to lift up at the window ledge and then you can remove the wiring harnesses from the panel to get it out of the way.
With the window jammed (with a wooden wedge) in the up position, you will see a hex head screw holding the window mechanism to the glass at each end of the glass. Just loosen these two screws about one and half turns. Look at the motor bracket and you should see approx. 3 or 4 hex head screws holding the motor to the metal door panel. Remove those screws and you should be able now to wiggle the window motor and mechanism out of the door panel. You will probably find that the braided cable connecting the motor pulley to the window arms has broken or is jammed inside the motor. I have taken this apart, reset the cable but it only worked once again before it jammed up again inside the motor. Go to your local Auto Wreckers and order a replacement motor and mechanism complete assembly for about $150. GM wants double that price! Good luck!
Mekanic
SOURCE: license plates light
check light socket grounding...repair as necessary Check power at hot side of light socket with a test light, grounded on a clean unpainted part of chassis. If light lights, then check ground side of socket.
SOURCE: Instructions for programming a 2003 Buick La Sabre Keyless Remote
fifty is cheap and should pay it because no else can program the remote because it must be done through the computer.
SOURCE: need to replace fuel pump on 97 buick la sabre
it's in the fuel tank! need to get it u in the air about 4 or more feet of the ground. you may get away with it being less and there is two straps holding the tank it they are attached to the body with 15mm bolts. you will need to disconnect the filler neck where you put gas by taking the hose clamps off and then disconnect fuel lines and electrical after you have it half way down straps removed! ask any more question you have
107 views
Usually answered in minutes!
×