Where is the airbag system fuse in 05 jeep liberty

pull fuses

The air bag system is not fused, if your light is on the system is disabled and will not deploy in an accident. Have it checked for fault codes

Normally the fuse and relay layout is under the cover to the fuse panel your inspecting. I am trying to upload a schematic for a 2016 Jeep Liberty not knowing what year yours is. In the schematic it shows two power supplies to the radio, one is a 10amp and the other is a 15amp fuse. this would be typical of the radio u are dealing with. you can email me at [email protected] with the year and I will send pdf files needed for your year and fuse/relay layout.

stevan

The likely cause of this is a defective rotating printed circuit coiled contact under the steering wheel, it is referred to as the "clock-spring" contact coil. To replace it requires the very dangerous airbag system be disarmed and the steering wheel removed, it is directly under the wheel. Before replacing any parts have the problem diagnosed to confirmed my guess work.

The most probable reason for the code is the battery being dead for a while, there is a capacitor in the airbag circuit to make sure the airbag can go off in a collision even if the battery disconnects itself in the process. There is a slim chance it might be something else but either way the shop should be able to tell you what the problem is, and get it fixed; sometimes, scanner reader could helpfull to know exactly what fault code is stored there. keep in mind that this isnt an OBD codes reader, this is more specific for Airbag Systems.

Also, isnt rare to know that the airbag warning light is indicating the airbag(s) may not be functionig. As it says in the manual, "Ignoring the AIRBAG warning light in your instrument panel could mean you won't have the airbags to protect you, (or your passangers), in a collision...have the airbag system checked right away". Always wear your seatbelt. On 2004 there is a light on the passanger grab bar that indicates the passanger airbag is off. This happens when a child is in the seat to protect the child from the sudden force of an airbag. It can also be fooled by a package or briefcase on the seat. This is normal. When an adult sits on the passanger side the light should go off. This information was an addition to the 2004 manual.

Check THIS ARTICLE for additional details.

Hope this helps.

Actually the Airbag Sensors would be located Close to the Radiator and can be disabled by removing the Airbag Fuse. To locate the Airbag Fuse look for a diagram near you fuse panel sometime located on inside of fuse panel cover if not it will be located in your Owners Manual. In this Diagram there should be names attached to each fuse just locate the one that has Airbag System on it. An easier way to achieve this is to disconnect the Negative Battery Cable from the Battery and be sure it stays away from the battey far enough to ensure that no power is able to travel to the fuse box.

Thumbs Up if Helpful!
Feedback is Appreciated!
Good Luck!!!

is there power to the horn if there isnt check the horn relay probably bad

It's never a great idea to dis connect any safety feature on a vehicle. But should you wish to do so here are two possible options. BMW may have a key operated switch (usually ignition) to disarm the passanger side airbag (usually in the case of rear facing child seat being fitted) OR if you manually disconnect the airbag (NOT reccommended) you will have to insert a resistance into the passanger bag circuit of equivelant to the air bag that was removed.In order to maintain the self diagnosis check system.

IM LOOKING FOR SERVICE MANUAL TOO. HOPEFULLY DOWNLOADABLE ONE.
ANY HELP ([email protected])

The system needs to be checked for cades. Airbag codes are pulled out of the ECU with the use of a scanner tool. A good auto mechanic shop will have this or you can go to the dealer. YOU SHOULD NOT TRY TO REPAIR THIS YOURSELF,YOU COULD ACTIVATE THE AIRBAG!!!!!