1997 jeep grand cheorokee larado v6. truck is acting like my previous 2001 jeep cherokee when i tried to start it with my valet key. The 97 jeep does not use the key with the sensor. I am getting no spark and the security light in the dash does not blink like it use to. When i turn key to on position the gas empty light goes on (plenty of gas in it) and about 20 seconds later the red dash security light comes on and stays on. This has never happened before. any ideas. thank you.
- If you need clarification, ask it in the comment box above.
- Better answers use proper spelling and grammar.
- Provide details, support with references or personal experience.
Tell us some more! Your answer needs to include more details to help people.You can't post answers that contain an email address.Please enter a valid email address.The email address entered is already associated to an account.Login to postPlease use English characters only.
Tip: The max point reward for answering a question is 15.
Get some "dielectric" grease and put it on your ecm contacts. Also clean your "grounds" very well. Mine was located on the passenger side of the engine block on my 97' Grand cherokee laradoe. Mine did the same thing yours was. These jeeps are a wiring nightmare for some stupid reason, and this will be your least expensive fix before you start replacing EVERYTHING like i did!. Best of luck!
Hi there: Check this information about your 1997 Jeep Grand Cherokee 4WD 4.0L MFI 6cyl...
- 42RE transmissionService change only - 4 quarts. Total refill - 11 quarts.
Hope this helps; also keep in mind that your feedback is important and I`ll appreciate your time and consideration if you leave some testimonial comment about this answer.
on the 2000 jeep cherokee fuse diagram was not included. makeing it hard in case of a short curcuit. fuse # 11 is a 20 amp. for the fuel pump relay. 97 to 2001 jeep cherokees. hope this helps !
×