2001 Hyundai Tiburon 2.0L MFI DOHC 4cyl
The Fuel Filter is located
Under hood, passenger side, front side of strut tower,
mounted on fenderwell.
I hope help you with this, remember rated this help.
Good luck.
Testimonial: "THANK YOU !!!!!"
Just changed filter on 01.its on the driver side strut tower,you will need to remove the air filter box for access.14 mm flare nut on bottom line,10 mm bolt on top line.book said the 01 only has screen on pump but it was wrong.
SOURCE: Fuel Filter
FUEL FILTER REPLACEMENT
1.
Reduce the internal pressure of the fuel pipes and hoses by completing the following operations.
(1)
Disconnect the fuel pump harness after removing the rear seat cushion.
(2)
Start the engine and after it stalls, turn the ignition switch OFF.
(3)
Disconnect the battery negative (-) terminal.
(4)
Connect the fuel pump harness connector
2.
Remove the bolt connecting the fuel line with the fuel filter.
Cover with a shop towel to avoid gasoline from splashing.
3.
Remove the fuel filter mounting bolt, then remove the fuel filter from the fuel filter clamp.
4.
After replacing the fuel filter, check for fuel leaks.
SOURCE: Replacing the fuel filter for 2001 Hyundai Elantra
it is above the tank next to the sending unit. remove tha bottom of the back seat and there is an access panel remove this and you'll see the fuel filter
SOURCE: locate fuel filter, and safety switch to fuel pump
The filter is located at the rear seat, you have to remove it first, then you will see a cap attach with some screws. Inside that cap you`ll find the fuel filter. Before you change the fuel filter you have to release the fuel pressure first. To do that, first find the FUEL PUMP RELAY in the main fuse box located in the engine. Once you located open the fuel door and take off the cap and leave it open. Start the engine, take off the FUEL PUMP RELAY and leave the engine stop itself, when this occurs turn off the key, the you can take off the filter and changed it
SOURCE: Where is the cabin air filter located on an 07
The cabin filter is located behind the glove box.
Remove the three screws along the bottom edge of the glove box door.
Open the glove box door and remove the three screws along the top edge just inside where the door closes.
Pull the glove box assembly out and you will see the cabin filter cover behind it. It is a (approx.) 1.5"x10" plastic plate that snaps out.
Remove the cabin filter cover and slide the old filter out, noting the orientation. Install the new filter in the same orientation then reassemble the vehicle.
Testimonial: "Very helpful. Thanks!"
4,613 views
Usually answered in minutes!
×