Replacing bulb (Headlight) in 2000 accent GL

Check the bulbs could be blown low beam

location of oil pressure sensor on 02 hyundai accent gl with a 1.6 liter engine is driver side front of engine. lower near the bottom of the radiator.mind you that is for a 1.6 l

Here is the only literature I could find to help you. It is located in the Hyundai Accent Owners Manual under "Do It Yourself Maintenance" The shop manual doesn't even list the headlamp bulb, let alone tell you how to change it. Apparently, it is so simple to change, that they did not feel the need to explain it much.

Hope this helps and please don't forget to rate! Thanks!


Removal & Installation

1. Disconnect battery cable.
   
2. Remove the head lamp bolts.
   
3. Disconnect the head lamp connector.
   
4. Remove the head lamp.
   
5. Installation is the reverse order of removal procedure.
   

Headlight bulbs-2000-2005 Accent

the cover dont remove.....the bulb comes out the rear of the housing under the hood

Check this reference guide...

2002 Hyundai Accent Car Lightbulb Size Guide
Low Beam Headlight Bulb Size: 9003/HB2
High Beam Headlamp Light Bulb Size: 9003/HB2
Parking Light Bulb Size: 2357A
Front Turn Signal Light Bulb Size: 2357A
Rear Turn Signal Light Bulb Size: 1156
Tail Light Bulb Size: 1157
Stop Light Bulb Size: 1157
High Mount Stop Light Bulb Size: 921
License Plate Light Bulb Size: 168
Back Up Light Bulb Size: 1156
Front Side Marker Light Bulb Size: 2357A
Rear Sidemarker Light Bulb Size: 168
Map Light Bulb Size: DE3175
Dome Light Bulb Size: DE3175
Step/Courtesy Light Bulb Size: DE3022
Trunk/Cargo Area Light Bulb Size: DE3022

From Sylvania Lamp Replacement Guide
License plate
168
168LL Long Life Upgrade: Up to twice the life of the standard lamp.


I hope help you with this. Good luck (remember rated this help).

the grounds may be bad they are behind headlamps but more than likely it is the switch

http://www.hmaservice.com/.. register. Lots of shop manuals, wiring diagrams, etc.

Some imports require the entire light assembly to be removed in order to replace headlamps. Look to see if there are angled rods on the back side of the light assembly. If so, see if the can be pulled straight up towards the hood of the car. When they are released the headlight will be able to come forward. Good luck. Hope this helps.

no its not difficult need to know where to look for a used one or new aftermarket one go to collisionrepairadvice.com and get instructions on the how to do it yourself but it may be able to just tighten up.