At Fixya.com, our trusted experts are meticulously vetted and possess extensive experience in their respective fields. Backed by a community of knowledgeable professionals, our platform ensures that the solutions provided are thoroughly researched and validated.
- If you need clarification, ask it in the comment box above.
- Better answers use proper spelling and grammar.
- Provide details, support with references or personal experience.
Tell us some more! Your answer needs to include more details to help people.You can't post answers that contain an email address.Please enter a valid email address.The email address entered is already associated to an account.Login to postPlease use English characters only.
Tip: The max point reward for answering a question is 15.
Have you had vehicle check for DTC'S diagnostic trouble codes . Check fuse's an relays , find wiring diagrams to see what controls these systems ?
Radio/Battery fuse , fuse G 10 amp located in the right instrument panel fuse box . Do you know where this ?
Fuse Block - Right IP - On the right side of the instrument panel
An there is one on the other end of the instrument panel ,driver side .
Fuse Block - Left IP- On the left side of the instrument panel The fuel an temp . gauges not working is probably the step motors inside instrument cluster . GM had problem with this 03 to 06 . How to repair GM Instrument Cluster Speedometer Gauge Stepper
Daytime Running Lamps (DRL)
The ambient light sensor is a light sensitive transistor that varies its voltage signal to the body control module (BCM) in response to changes to the outside (ambient) light level. When the BCM receives this signal it will either turn on the daytime running lights (DRL) or the headlights. Any function or condition that turns on the headlights will cancel the daytime running lamps operation. With the headlight switch in the OFF position, the headlights will either be turned ON or OFF, after an approximate 30 second delay depending on whether daylight or low light conditions are sensed. The HTR A/C IGN fuse in the underhood junction block supplies ignition positive voltage to the daytime running lamp (DRL) relay coil circuit. The DRL relay switch contacts are connected to the low beam circuit. When the headlamp switch is placed in the OFF position, the BCM will either turn on or off the daytime running lamps, depending on whether daylight or low light conditions are sensed. The BCM energizes the DRL relay, closing the switch contacts and grounding the low beam circuit. Ground is provided at G101. The DRL illuminate the low beam headlights at a reduced intensity. The DRL will operate when the ignition switch is in the ON position, the gear selector is not in the PARK position and the parking brake is released. When these conditions have been met and the ambient light sensor indicates daytime conditions, the DRL will illuminate.
DRL operation in Manual Transmission equipped vehicles will occur when the ignition switch is in the ON position, and the parking brake is released. - check fuse's an relay first.
Door Lock System Components
The power door lock system consists of the following components:
?€¢
Driver door lock switch
?€¢
Front Passenger door lock switch
?€¢
Body Control Module (BCM)
?€¢
Relays: Driver Door Unlock--if equipped, Door Unlock, and Door Lock
That piece you think is a ceramic DRL module is a resistor , When in DRL mode voltage to the low beam headlamps circuit goes through that resistor dimming the headlamps from low beam to daytime running lamps . It sounds to me like you need a new resistor ,but without doing some electrical testing it could be a lot of things . The DRL relay in the under hood fuse box could have a problem , could be the BCM - body control module , the ambient light sensor etc... Here is how daytime running lamps work .
Daytime Running Lamps (DRL)
The ambient light sensor is a light sensitive transistor that varies its voltage signal to the body control module (BCM) in response to changes to the outside (ambient) light level. When the BCM receives this signal it will either turn on the daytime running lights (DRL) or the headlights. Any function or condition that turns on the headlights will cancel the daytime running lamps operation. With the headlight switch in the OFF position, the headlights will either be turned ON or OFF, after an approximate 30 second delay depending on whether daylight or low light conditions are sensed. The HTR A/C IGN fuse in the underhood junction block supplies ignition positive voltage to the daytime running lamp (DRL) relay coil circuit. The DRL relay switch contacts are connected to the low beam circuit. When the headlamp switch is placed in the OFF position, the BCM will either turn on or off the daytime running lamps, depending on whether daylight or low light conditions are sensed. The BCM energizes the DRL relay, closing the switch contacts and grounding the low beam circuit. Ground is provided at G101. The DRL illuminate the low beam headlights at a reduced intensity. The DRL will operate when the ignition switch is in the ON position, the gear selector is not in the PARK position and the parking brake is released. When these conditions have been met and the ambient light sensor indicates daytime conditions, the DRL will illuminate.
If you turn car off and remove key from ignition, th? headlights will stay on until you open the driver side door, its part of an auto on headlight system. you can leave your selector light switch on the headlight position or on the daylight lamp relay (DRL) position. and open the driver side door and the lights will go out and not stay on. so it saves running your battery down. That feature is only on SLE trim line on the Solara.
Start by setting your auto headlight switch to off if this solves it replace your headlight switch If your car is equipped with daytime running lights there could be a short bridging them with your auto head lights look for broken or frayed wires do this also if you have installed or had someone install an aftermarket stereo or speakers/sub woofer, amplifier. Good Luck with this
WHAT YOU MIGHT CHECK IS THE FUSE FOR TAILLIGHTS, OR DASH LIGHTS. THEY WORK OFF THE SAME FUSE. IF THE FUSE IS BLOWN THE HEADLIGHTS WORK BUT NO TAIL OR DASH LIGHTS
×