At Fixya.com, our trusted experts are meticulously vetted and possess extensive experience in their respective fields. Backed by a community of knowledgeable professionals, our platform ensures that the solutions provided are thoroughly researched and validated.
Re: Location of temp.control sensor on vw polo 2002 1.2
Hi rabing
This sensor is located in cylinder head. Depending on engine code, this
sensor is also a sensor for tick-over fuel / air mixture. If this is the case there will be 4 wires fitted to it
John
- If you need clarification, ask it in the comment box above.
- Better answers use proper spelling and grammar.
- Provide details, support with references or personal experience.
Tell us some more! Your answer needs to include more details to help people.You can't post answers that contain an email address.Please enter a valid email address.The email address entered is already associated to an account.Login to postPlease use English characters only.
Tip: The max point reward for answering a question is 15.
https://fuseandrelay.com > volkswagen > polo-sedan
Complete information on all fuse and relay boxes in the Volkswagen Polo mk5 mk6. Locations, photographs and box diagrams with the designation of elements.
5: 5A Power package control unit
2: 30A Cooling fan motor control unit, cooling f...
1: 25A ABS control unit
3: 5A Cooling fan motor control unit
does the temp gauge reach the red area? check eng coolant .Over heating could cause eng to cut out so as not to cause more damage check the cooling system.When travelling slowly or at stand still turn heater to max heat and max speed this will cool eng but is only a temporary solution
Hi, the knock sensor should be located under your intake manifold on the front (depends how you take a look at it) of your engine block. Its round and black with a screw in the middle.
Crankshaft sensor is located on the right side of the cylinder block behind or under the starter. It is fitted into the rear crankshaft oil seal hausing
Im guessing it is a jetta? I never heard of a polo. BUT the guy at the garage obviously didnt help you out very much except scanned for codes. ANYWAY.... P0116 means Engine Coolant Circuit Range/Performance. I recommend checking engine coolant temp[ECT] sensor G62. It probably needs to be replaced. And a coolant flush would probably be good to
Hi, I have a 2001 polo 1.4 mpi it lackes power when you hit a hill it just dies, It has had new cat, fuel filter, fuel pump and throttle body, but is still the same it just dose not want to give me full rev's?
try disconecting the coolant temp sensor and then try, it may be faulty, also check the hall sender unit in the distributor, if it has one, the centre pin should be the signal wire if no pulse is present the sensor is faulty
Hello, VW polos 1.0, 1.4. 1.6, suffer from carbon bulid up in the throttle bodys causing bad idling, esp the Bosch Mono-Motronic (Throttle Body Injection systems), a good clean with carb cleaner should repair the problem, also engine temp sensor replacement and idle speed control valve replacement can help idle problems.
×