Peugout boxer 2.2 hdi servicing sign keeps coming

battery light on means alternator is not charging for one reason or another, usually need new alternator

Hello kenny,This article is showing the instructions of replacing fuel pump and fuel filter,you can read it ,How to Replace Fuel Pump and Fuel Filter

hi, the airbag ecu is in the bottom of the center of the dash.
cheers

Has the fuel pressure been checked?

Did you ground it because you need to ground it my friend

The oil light flashing on your 2007 boxer 2.2 hdi is a service due indicator. will need resetting with compatible diagnostic equipment.

{: ) The two triangles you saw is for the StabilTtrak system,, sometimes called the traction control indicator. When you see a spanner beside it, it means the system needs servicing.
StabiliTrak will turn off automatically if a problem is detected in the system. For vehicles without a DIC, the StabiliTrak light and the StabiliTrak service light will both come on. If the StabiliTrak service light does not clear itself after restarting the vehicle, you should see your dealer for service.

I just checked on that one, they said to disconnect the battery for 5 minutes, and the lights will reset? I have heard this but never had to try it. Your spanner is scheduled maint and the oil light you know. And they both should be resettable. Hope this helps.

Perform the following

Turn the ignition off
Press and hold the milometer push button (the button for reset the miles mostly the right hand push button on the dash)
Turn on the ignition (do not start the car!)
Wait for the display countdown to reach 0
Release the milometer push button
Turn the ignition off.
Turn the ignition on and check that the correct mileage till the next service is displayed

The spanner or wrench you are seeing indicates how many miles are remaining before your vehicle is supposed to have the oil changed. Normally this is about a 10,000 mile interval and may be reset after an oil change by following this procedure...



Do the following steps:
Move start switch to position "2".
Within the first 4 seconds after moving the start switch to position 2, press the reset button for the trip counter twice within one second. The display for the service request is activated for about 10 seconds.
Within these 10 seconds, move the start switch into position "0". The service request continues to be displayed.
Press the reset button for trip counter and keep it pressed.
Move the start switch into position "2".
Continue to hold the reset button for the trip counter pressed until the signal sounds and the new start distance appears in the display (it takes about 10 seconds).