2005 ford excursion cam sensor location I need to change the cam sensor and the crank sensors on my excursion and i do not know where they are located

5.4 engine ?

Hi Michael:
Here's the Google link that will give you all the info you will need.
https://www.google.ca/#q=Intake+air+temperature+sensor+2005+Ford+Excursion+Limited%5C
Cheers.

Do u hear your fuel pump kick on the three thing needed for a vehicle compression fuel and spark one of those will stop your vehicle from starting so or single coil pack but I think there individual now

the 5.3 and 6.0 are famous for bad crank sensor. never a problem with cam sensor. the crank sensor is located behind the starter. you need to remove starter to get to it. ther is one bolt holding it in. check the wires going to the sensor because they are so close to the exhaust the get brittle and brake. if the wire is good change sensor and your car will run fine

You have not indicated that you have even had the basic test done which is a OBD2 fault code test, please do this test.

the ones on the transmission

P1381 Cam Timing Advance is excessive if it were that your check engine light would be on it would be throwing code were gonna test what hes saying

I have a 2005 and the things that go bad on it is when the sensor goes off then for the intake then where the butterfly is on the intake gets dirty and needs to be cleaned it is the venturi gets dirty and needs to be cleaned and if it is a cam crank then it is the cam actuator that needs fixed you can tell if you take it off and there a screen missing it is a good sign that it needs be replaced and it is on the left side of the engine you need to understand that if it gives you a code that tells you that it is a sensor that is telling you that what the sensor looks after is bad not the sensor

Repairing the 7.3L PowerStrokes can be hit and miss, there can be a number of things wrong and even a combination of things. The first thing I would try changing, if engine is turning over, is to change the Cam Position Sensor (aka CMP sensor). This is a Ford recalled sensor that is easy to change. It is located on the front, bottom, passenger's side of the engine. It only requires that you remove the electrical plug-in on the sensor and remove one bolt and the sensor should come out with some wiggling. Install the new sensor the opposite way you took the old one off. If that does not work then come back to fixya and we'll help you figure it out.

If your Excursion has the 7.3L Diesel, what I first suspect is the Ford recalled item Cam Position Sensor (CMP sensor). If your nearby Ford dealership has not replaced it for free for you, then make an appointment and take the car in to have the sensor replaced. If this does not solve your stalling problem, come back to FixYa and I will assist you further.