The old plug fell apart before we took a picture of it. I just have 4 wires hanging that will slide into new plug. Just not sure of order. If anyone has a picture or color code of it would be great. New plug has no wires its a factory OEM plug. Was told 4V engine.
SOURCE: 1998 mustang gt coil wire diagram
If the colours on the new plug are different,no problem. Just make sure the same amount and colour go back to the original holes/terminals.
If you still need help, you should let us know which engine you have.Also if it is a 2V or 4V.
SOURCE: Need a wiring diagram for a 1969 Ford F250.
there should be a slot for each wire on back of ignition play with them till you get it right cant hurt anything
SOURCE: i need the radio wiring diagram for a 1992 cadillac eldorado
white is front left. greay is front right. green is rear left . purple is rear right. black is ground .yellow is power. red is ignition. or do u need factory wiring? the12volt.com try this website it is very helpfull
SOURCE: it was wired for a 4 wire flat trailer plug. the
You need to install a 3-2 wire converter. I suggest a CURT 56175 then
1.Using a test lamp, identify the corresponding wires in the
harness for the left turn, right turn, tail lights and brake lights.
3. Temporarily remove the vehicle's negative battery cable from
the battery.
4. Using wire taps, attach the input wires of the tail light
converter to the corresponding vehicle harness wires identified
in step 2 as indicated.
Converter Brown Wire: Tail Light Circuit
Converter Yellow Wire: Left Turn Circuit
Converter Red Wire: Brake Light Circuit
Converter Green Wire: Right Turn Circuit
5. Locate a suitable mounting location for the ground eyelet on
the vehicle near the converter on vehicle's frame or cross
member.
And your ready to tow!
343 views
Usually answered in minutes!
×