Is there a bypass switch for steering lock on 2004 SAAB 9 3 convertible

SOURCE: Adjust headlights on a 2004 Saab 9-3

Check the fuse box under the hood on drivers side, it will be number 17 and a 10 amp. this vehicle has automatic headlight adustment when you crank the car. If the fuse is blown the lights will point down to keep from blinding oncoming traffic.
Hubert

SOURCE: Saab 2004 9-3 Convertible

Had same problem, in the boot right hand side, behind the removable panel there is :
1 - a hydraulic reservoir which must be at correct level.
2 - a black box (stc) this controls the roof system,
switch ignition off then pull the 2 connectors off for 30sec then reconnect.
This worked and hope this resolves your problem

SOURCE: i have saab 93 2004 and the Steering Lock

1º you need to now the DTC`s(default codes) and after follow WIS`s steeps.
WIS(work information system)

gord storey

• 477 Answers
• Posted on Nov 09, 2009

SOURCE: how do I replace my 2004 Saab 9 3 linear's water pump.

Re : the computer , they better cover it under warranty or they ****.
Re : the water pump , you have a leak and they say it is the water pump , I have no reason to doubt that they have honestly checked out the problem and determined that a new water pump is the only solution but , damn $ 1000 is pretty steep. I would look around for another mechanic for a second opinion and a quote. Avoid dealerships. Not sure what engine you have but i just looked in my saab with a 2.3 and hope I never have to do mine. I am pretty good with a wrench but I know there would be lots of swearing involved.

SOURCE: green hydralic liquid coming from convertible top saab 2004 9-3

You are probably leaking hydraulic (ATF) fluid.
Check the lines and cylinders for leaks. Replace any leaking lines or cylinders. Always replace them in pairs.
When the leak is fixed...
Behind the rear seat is the motor/pump/reservoir.
With the top down, fill the reservoir with ATF.
Cycle the system a few times.
Repeat till the reservoir will accept no more fluid.
You can change it to a manual top by removing the bolt at the top of the cylinders and lowering the both shafts down into the cylinders.

Karl at topgunwon.com