2004 dodge grand caravan. check eng light.. rotated key on and off 3 times seen code 0073 where mileage would of been then dotted lines then the word done...??

Check fuel pressure check spark .cycle key 3 times and count check eng lite blinks 12 is starting code rest
Eng codes 55 end codes








g Lt.Blinks

Here's a link showing you where it's at. 2001 2004 Dodge Caravan Cabin Air Filter Check 2004 Dodge Caravan SXT 3 3L...

That's normal for Chrysler minivans. Clear the code and don't worry about it unless it happens again.

I’m happy to assist further over the phone at https://www.6ya.com/expert/jeremy_d728a59f986299fa

Sounds like you have a problem with the ignition switch, key or security system. You will need to get it checked to see witch one. I wouldn't wait too long because it will get worse and leave you stranded.

If this happened over a short period of time. have the catalitic converters checked. They're clogged, insuffient air flow. Also check for codes. just because the light is not on doesn't mean there is not a code.

my 2003 grand caravan 3.3l run for 30 then daying and fuel pump making noise you can restart again it run for 2 to 3 min dies again pep boys change crank sensor fuel pump no help when eng shutdown middle of high way or trafic no fuel to eng does have elect power no eng check light any help

my e-mail is [email protected]

What signal is this? is this for a check engine light code?Okay i know what you mean, it a p0073 code, this is the ambeint temp sensor,this is the sensor that tells you the outside temp on your display, the sensor may be bad ,misssing or bad wire going to sensor,was this van in a crash, lots of times the sensor gets damaged from an accident,

This sounds like a classic bad connection either at the battery or engine ground. Check and recheck all your connections and be sure they are clean and tight.

That is a code for the secondary (spark) circuit on cylinder number 3. It is usually caused by a bad connection between the coil and the plug (take the coil off the plug and check for moisture in the boot). If not, it might be a bad coil...

that would be a crank sensor code 10