Question about 1996 Oldsmobile Cutlass Supreme Coupe

1 Answer

All instrument panellights come on dont start

Also rear brakes lights don't come on until i pull the turning signal/high beam bar slightly forward as if to turn on high beams on but not all the way to engage the high beams

Posted by on

Ad

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Vice President:

    An expert whose answer got voted for 100 times.

  • Master
  • 437 Answers

Turnsignal switch unit is faulty and needs to be replaced that will fix the brake lights. Dash problem i think will be a different problem. need more info

Posted on Aug 26, 2009

Ad

1 Suggested Answer

6ya6ya

6ya staff

  • 2 Answers

SOURCE:

Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Headlights not working on low beam


Replace the turn signal switch. All exterior lights run threw it except the high mount brake light.

Dec 01, 2015 | 2007 Chevrolet Chevrolet Uplander

1 Answer

Turn signals and high beams


First check around all the lights (front, rear, headlight, turn signal, parking, fog, etc..) for loose, broken, or bare wires, and/or loose , broken, or bad connectors. Any of these could cause the lighting to short. If everything is in good working order, then the problem will most likely lie with switch inside the column (the lever).

Jul 15, 2008 | 2001 Volvo S80

1 Answer

Hi Beam don't stay on VW Beetle 2002


It's the turn signal switch that is faulty.

Jul 26, 2015 | Cars & Trucks

1 Answer

I have a problem with the low beams on my headlights. The high beams works just fine. All of the other lights(turn signal, emergency lights, etc.) work except for the low beams.


Check the fuses first. then replace the turn signal switch if all fuses are good. All the lights run threw it, except the high brake light on the rear.

Jan 01, 2015 | 2003 Ford Escape

1 Answer

My 1984 chevrolet silverado high beams lights works and low beam lights, turning lights, emergency light and brakes lights don't work. I need help!


Those lights are on different circuits. The high and low beam lights are powered thru the headlight switch, the turn signals, brake, and hazards go thru the turn signal switch.
I would want to know if each circuit has power at the switch that controls it.

Jun 28, 2013 | Cars & Trucks

1 Answer

How do i fix a faulty ignition swicth on a '97 cabrio?


The wiring should not be crossed unless it was in a bad accident that pinched wires or a repair was done to it by someone who did not know what they were doing.
You seem to have several issues, if you are mechanically inclined, I would recommend that you begin by replacing both, ignition switch and the turn signal switch, which also activates your high / low beam. Then proceed diagnosing the park brake problem and finally your ABS issue.

Jun 26, 2017 | 1997 Volkswagen Cabrio

1 Answer

I have a 1996 Jeep Cherokee. Headlight Problem: Year ago? Switched on high beams, complete darkness (low beams don't work at the same time I've come to find out). Solution: Don't turn on...


ok, first ,, check all the bulbs again, and *** make sure that your hands never touch the actual bulb, these lights will turn the oils from your hands into cooking grease when it comes to these bulbs and cause them to blow out much to early on in their life span, , next,, Pull the light switch ( high beam switch towards you for a quick flash of the head light high beams,, if this doesn't make the high beams come on, your problem is going to be in the switch itself ( what your calling the high beam/turn signal lever) before going to that extreme though,, if you have a junk yard near you, go pull one of the relays off a junked vehicle, and stab it into your system one at a time, it could be something as simple as a relay heating up and disconnecting prematurely due to heat ,, if you don't have a junk yard that you can grab a relay,, here is a link that shows how to check them, But its time consuming http://www.youtube.com/watch?v=C8t25GjZ6i4&NR=1

Aug 10, 2011 | 1996 Jeep Cherokee Sport

1 Answer

My light problem is i have low beam on right side no low on left side i turn highs on and right side goes out and high on left turns on then when back to lows beams and i pull turn signal to flash high...


If you have separate bulbs for the low and high beams(4 light system), if you pull the turn signal and hold it, all 4 lights will stay on until you release the turn signal. You need to replace the bright bulb on the right side and the low bulb on the left side. If your headlights only have one bulb on each side, then you will have to replace both of them to get everything to work.

Jan 04, 2011 | 2000 Ford Mustang

1 Answer

DRL and High Beam do not work right on Honda Accord EX 1998


Some time back I found some data on a similar website suggesting that the Day Light Running circuit board, just under the steering column, developed cracks in some of the soldered joints. Your high beams should also be affected with loss of day light running lights.
Resoldering repaired the continuity of the circuits. Ours is now working quite reliably. Some of the defective areas developed slight brownish discoloration, that's how I was told to recognise the areas to be resoldered. Hope this will help you solve your problem.

May 24, 2008 | 1998 Honda Accord

Not finding what you are looking for?
Cars & Trucks Logo

67 people viewed this question

Ask a Question

Usually answered in minutes!

Top Oldsmobile Experts

Jonah Oneal

Level 3 Expert

14092 Answers

Marvin
Marvin

Level 3 Expert

85216 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22485 Answers

Are you an Oldsmobile Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...