Traditionally the hazard switch is where the direction indicators are switched from the indicator stalk switch and ignition switched supply to battery supplied hazard lights. By 1996 these functions were rapidly being computerised so taking things for granted is definitely unwise.
I strongly suggest you obtain a wiring diagram before getting too involved...
SOURCE: 99 jeep cherokee Blinker problem
Hi Bill,I think before replacing anything else you should give that hazard switch a good workout.The switch doesn't get get used very often and the contacts get corroded and can upset the indicators.Good Luck.
SOURCE: on a 1996 Plymouth grand voyager, where will i
It is in the fuse/junction block in the interior of the car. I don't have a cavity location, but if you have the new flasher, you should be able to match it up.
SOURCE: 1996 plymouth voyager, where is turn signal
Hello. the flasher is under the dash, usually between the radio and the steering column. J.
SOURCE: 1996 Plymouth grand voyager engine
Is this an intermittent problem? How often do you change your fuel filter? It could be caused from impurities in the gas tank. If there are no OBDII codes, I would replace the fuel filter and check the fuel delivery components (ie fuel injectors, fuel pump). Don't have a mechanic change the coil - they like to replace the coil because usually it's on top of the engine and easy to access. They just unscrew a couple bolts and slap on a new coil and charge $40-$60 an hour in labor + the coil.
SOURCE: need wireing digran for 1996
When the ECM is replaced you need to have it reprogrammed. It may run the engine for a bit but there are t many variables to keep it going. Some auto parts stores are doing this now. call around. Much cheaper than a dealer. If you had it reprogrammed then you need to check the codes. This will give a direction to go.
Randy
80 views
Usually answered in minutes!
×