2005 Chrysler sebring convertable wont start code reads done

James Bradburn

• 299 Answers
• Posted on Jan 18, 2009

SOURCE: 2003 chrysler sebring

Could be starter, or neutral switch in the tranny.

SOURCE: replace air filter 2002 Chrysler Sebring convertible

you need to loosen the clamp on the throttle body and unplug the map sensor then there are two clips on the other end pull that out and you should be able to pull the filter out you don't need to take the box off.

SOURCE: p1128 code

I looked on alldata, and my Chrysler site, and there is no P1128 code listed. Are you sure the code is correct? What motor is in it? I looked for the code online for generic reasons, and it says it is for upstream heated O2 sensors swapped. Never heard of this code ever in 14 years of service work.

SOURCE: I HAVE A 2005 CHRYSLER SEBRING AND DOME LIGHT,RADIO ALL POWER LOCKS HAVE QUIT WORKING

me too! - looking at fuse #5 red 10 Amp one but has black thing on it.

Can't get if off..

Have read the manual is wrong and to use panel on side of fuse box for fuse locations...

SOURCE: I need a timing belt diagram for a 2005 chrysler sebring

My sincere apologies for the delayed response.
I am personally going back to answer your unanswered questions.
I have only been a free contributor to this site for the past 4-months.

I do not know if you still need this information, but I am going ahead and answering it anyway. You may want to Print the Diagrams for future use.

CLICK on the following LINK. It has the Belt Diagrams you will need.

If you would: Before Clicking: Let me know if this helped you, or if you have any additional information or questions. Feel Free to contact me at FixYa.com!

Again my apologies...
http://www.2carpros.com/car_repair_information/year/2005/make/chrysler/model/sebring/2005_chrysler_sebring_timing_belt_diagram_marks.htm