Car wont start turns over just fine but no spark

After so many over heats.a car sometimes cant handle.
after constant over heating your cars rubber gaskets could have gone bad and turned brittle letting in oil into spark plug well #1
for your spark plug problem i would recommend changing your valve cover gaskets.
and for the over heating and not turning on.
i believe you blew a head gasket.

Most common problem when this happens is the ignition module,complete distributors are available at low cost because of this common problem.Do you have spark?

Sounds like a starter. next time it does it try to tap on starter with screw driver handle or hammer handle just a couple taps then try to restart car if starts then starter is going.

Are the wires in the right place? Sounds like you crossed them.

DID YOU HAVE SPARK IN THE SPARK PLUG WIRES WHAT YOU CAN DO IS TAKE OFF ONE OF THE WIRES FROM THE SPARK PLUG AND PUT A FLAT SCREW DRIVER INSIDE THE WIRE AND PUT IT CLOSE TO THE METAL SO THE WIRE GETS GROUND AND HAVE SOME ONE TO CRANK THE ENGINE AND YOU GOING TO SEE THE SPARK IF YOU DONT SEE SPARK SO THAT IS YOU POBLEM

replace it

are you getting any spark on the #1 cylinder?

make sure your battery is charge and check your cowl pack to make sure you have spark and check your drive belt to make sure it not slipping

make sure you have pressure to your fuel rail, if you do , then check your timing it could have jumped or be off, make sure you have spark to all four wires. and for the fuses turn your ignition key to on position and get a test light, ground the test light to a good ground and apply the light to both slots of each fuse, if it lights on both sides of the fuse then the fuse is good, if it only lights on one end of the fuse the fuse is probably bad so pull it and look to see if its fried, and if it doesnt light up on either side it is most likely good, thats about all i can think of, hope it helps

You might have to change the spark plugs or at least have them cleaned.