I have a very bad misfire while I'm driving my 2005 Chrysler Pacifica. It's so bad I amunable to drive it. Any idea on what I should do? (Note: I already replaced the PCM, that's what my local dealer told it was, and it wasnt that causing the misfire.)

SOURCE: I need to replace the thermostat for a 2005 chrysler pacifica

Follow the Upper Radiator Hose to the Block. There is a Bell housing there that the Hose Connects to. Remove that Bellhousing and the Thermostat is Right Under it.

Todd Bradshaw

• 141 Answers
• Posted on Feb 14, 2009

SOURCE: Brake fluid reservoir on a 2005 Chrysler Pacifica

WHEN YOU OPEN YOUR HOOD LOOK DOWN THE DRIVER SIDE FENDER THEN LOOK LEFT ABOUT 10 INCHS AND YOU SOULD FIND IT IT WILL BE WHITE IN THE ENGINE COMPARTMANT AREA

SOURCE: Chrysler Pacifica 2005

Sure, you can buy a new pulley and replace the original one but, you may have bad alternator bearings that is causing this noise you are hearing. i would check this out before buying a new pulley.

SOURCE: program instruction garage door opener in 2005 chrysler pacifica

if your garage motor have rolling codes you need to put your car inside garage near the motor leave ignition on go to the motor locate learn button press it then quickly go to the car and press and hold one of the buttons for approximately 30 sec or until it start blinking rapidly, if you have a regular motor take one hand held opener go inside car ignition on same time press open button on handheld remote and on the car button 30 sec and it should be programmed.

SOURCE: MY 2005 CHRYSLER PACIFICA WONT TAKE FUEL, IT

check for recall on fuel system,our car was doing same thing also fuel gauge would drop at half a tank to empty,took it to dealer they fixed it and did not charge me a dime.