Location of the cam shaft sensor in a 2001 Oldsmobile Aurora 4.0 v8

Where is the horn located under the hood in the Oldsmobile ...

https://www.answers.com > Where_is_the_horn_located...
Oct 6, 2014 - In the 2001 Oldsmobile Aurora, the horn is located under the left headlamp on the left front corner of the car. The Oldsmobile Aurora ...

How To Fix Replace Repair Horn On Oldsmobile Alero ...

https://www.youtube.com > watch
PREVIEW
4:03 How To Fix Replace Repair Horn On Oldsmobile Alero Pontiac Grand Am, Please Subscribe Now!Alero/Grand Am Hi Tone Horn: ...
YouTube · Ay8 Fix · Dec 27, 2018

Your Temp sensor may be hidden behind Your housing unit for the thermostat, and the O2 Sensor are alway screwed into the exhaust there is an upper and lower O2 sensor meaning Upper is up high on the exhaust near the engine and the lower one is down by the catalytic converter.

3.8 engine I have done few times,belt out,make way how goes,15mm. socket pull down to release belt,look what hold and remove all 15 mm. bolts.look wires and way go back.

According with the Owners Manual, on 2001 Oldsmobile Aurora 3.5L SFI 6cyl the Flasher is located: Under steering column support.

Hope this helps (remember to rating and leave a testimonial comment).

Hello crackinnutz: My name is Roger and I will help you. You will find the cam sensor located in the front of the right cylinder head.The sensor will be just below the lip of the valve cover and held in by a 10 mm. headed bolt. Should you need further help please just ask. Please rate the answer. Thank You for using Fix Ya. Roger

SOUND LIKE FAULT IN THE CRANKSHAFT SENSOR.

Crank sensor is in the bell housing of the transmission. Cam sensor is in the distributor.

2001 Oldsmobile Aurora 3.5 Liter Crankshaft Position Sensor (CKP) Location




Hope this help (remember comment and rated this).

replace the Crank Shaft Position Sensor.

2002 Oldsmobile Aurora V8-4.0 Replace Crankshaft (Sensors) A and B This car has 2 sensors 1- Raise and support car. 2- Remove the oil filter adaptor. 3- Remove crankshaft sensor electrical connector. For specific CKP sensor identification. 4- Remove the crankshaft sensor retaining bolt. 5-Remove the crankshaft sensor. NOTE= Inspect the CS sensor o-ring for wear or damage, if problem is found replace it also. 6- Lube O-ring with clean engine oil. 7- Install theretaining bolt TIGHTEN to 10 N.m (89lb in) 8-Install the CS sensor electrical connecror. 9- Install oil filtor adaptor. 10- Lower car. 11- Operate engine and inspect Cs sensor for oil leaks 12Perform the CKP system variation learn procedure.