2004 LS. Where is the cigar lighter fuse? - Lincoln Cars & Trucks

SOURCE: cigar lighter problem on 2005 Ford Explorer

even though the fuse is good, change it anyway and look for other bad fuses. it is possible that someone rewired and put wired them somewhere else. i just saw that yesterday. also, check to make sure a wire did not fall off or get broken/fried. if both power points are not working they are connected to the same power and ground points, whereby creating a circle/circuit. also check to see if one of the units is bad. if it take two to complete the circuit/circle and one unit is bad, maybe the circle/circuit is broken. you can test the units with two jumper wires and your battery/a jump box. these units are only + and -.

Marvin

• 85242 Answers
• Posted on Oct 16, 2008

SOURCE: The cigar lighter isn't working how do I fix this problem

This is a fuse problem, check the fuse, it will either be marked lighter or power point, the fuse box is to the left of the steering column it has a plastic cover over it, inside the cover the fuses will be marked on a diagram. If the fuse blows again the cigar lighter is shorted, you will have to replace it, most times the lighter element is the problem and not the well it fits into.

SOURCE: 2001 corolla fuse problem

inside the cover of the fuse panel there should be a diagram of which fuses control what.

the fuse box is usually on the drivers side by where your feet are.

SOURCE: Toyota Caldina 2001 no power to cigar lighter, radio, clock!

Hi there
If it was the front dash mounted lighter socket you used, the correct fuse is the 15A CIG & RADIO fuse (at the end of the second row) of the dash fusebox. If replacing the fuse hasn't fixed it, you may need to look closer at the wiring from the fusebox as it's likely the wiring has gone open circuit.
Take the fuse out and check for voltage at the terminals in the fusebox with the ingition key turned to the ACC position. One terminal or the other will have 12V on it. If no voltage on either you have a fusebox to ignition key wiring problem. Check for voltage on the ACC pin of the ignition switch, with the key turned to the ACC position. That's pin 3, a blue wire, of the 8 pin ignition switch connector. If still no volatge the switch is likely faulty. the voltage into the switch must be there as it also feeds the ECU and IGN systems, so the car wouldn't run at all if it wasn't.

There is another possibility. If you have an alarm system, immobilizer or turbo timer (assuming the GTT model) these devices could be interrupting the power lines and be the culprit devices.

I assume it wasn't the rear hatch area lighter socket you used, because the fuse for that doesn't power the radio or clock. The fuse for that socket is the 15A ACCESSORY fuse in the passenger side footwell fuse panel.

SOURCE: where is the 5 digit entry code sticker on an 04

It is a white factory code card,in the gray folder,with your owners manual. It will tell you how to put your own code in the Keyless Entry Keypad