Replace water pump in 93grand cherekee jeep

i hope this helps for the water pump. The thermostat is located at top of engine simply follow upper hose to engine and remove housing and replace thermostat.

check the throttle position sensor

If you need further help, I’m available over the phone at https://www.6ya.com/expert/david_4c166ba81493f541

The fuel pump is located inside the fuel tank. The fuel tank has to be disconnected and dropped down from the underside of the Jeep, in order to access and change the fuel pump assembly.

haynes repair book,,it is good to have if u plan on keeping the truck,,,,tells u step by step,,

What you should do..Since you already know whats wrong with your vehicle and seem to be embarking on fixing this your self...You should run out to your nearest
parts store and pick up the Haynes book for the dodge 600.
This will show exactly the steps you need to fix the water pump..Good luck

Hello Sir,

Here's a step by step proceedure to remove and replace the water pump on your Cherokee.

Be advised,all 4.0L engines, some 2.8L engines and some 4.2L engines have areverse rotating water pump. You can ID these from the word REVERSE orREV imprinted or cast on the housing and/or fan. There will also be an'R' stamped into the impellor.

Make sure your replacement pump is the correct type, If not, expect some major turmoil.

The procedure:
1. Remove negative battery cable
2. Open radiator valve - drain cooling system
3. Remove cooling fan and shroud
4. Remove belts (see my tip on serpentine belts if needed)
5. Remove water pump pulley from hub
6. Remove hoses from water pump
7. Remove accessory brackets from the water pump.
When removing the P/S pump and/or AC compressor, leave the hoses attached and move them out of the way.
8. Remove the remaining bolts and detach the water pump from the engine.The bolts are three different lengths. Make note of where they camefrom.
9. Compare the new and old pumps. Make sure they match.
10. Scrape off the old gasket material.
11. Apply a thin continuous line of RTV High Temp sealant to the water pump side of the gasket.
12. Put a couple bolts through the pump to hold the gasket in place and mount the gasket.
13. Apply Another coat to the other side of the gasket.
14. Attach the pump to the engine. Screw the bolts in finger tight.
15. Attach the remaining bolts.
16. Tighten them up in 1/4 turn increments.
17. Re-attach all the stuff you removed
18. Refill the coolant, adjust belt tension.
19. Run the engine and check for leaks.

Hope this is very helpful
Mike

i have a 2000 grand laredo jeep cherokee that is leaking fliud bad i think it the water pump how do i fix it ??

Replace the gas tank mounted fuel pump - AND the filter and gas guage sensor. $300-440 at a dealer.
Get them to clean out the water and "gel" (its parrafin I think) from the tank. Insist they do it.

what i will recomend you is to take it to an autorepair for a coolant pressure test, this will tell you what is exaCTLY leaking and then from there you desire if you want to fix it your self or let some one do it,

1. Remove negative battery cable
2. Open radiator valve - drain cooling system
3. Remove cooling fan and shroud
4. Remove belt
5. Remove water pump pulley from hub
6. Remove hoses from water pump
7. Loosen heater hose coolant return tube mounting bolt and nut.
8. Remove the tube. Lose the O-Ring.
9. Remove water pump mounting bolts
10. Loosen the clamp on the bypass hose.
11. Remove the hose as you pull the pump away from the engine.

Hope this helps

Mike