Question about 1995 Chevrolet Beretta

1 Answer

How do I cange the heater core in my 1995 Chevy Berretta

Posted by on

Ad

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

  • Chevrolet Master
  • 17,970 Answers

Start by removing the panel under the dash on the passenger side. You will need a regular phillips screwdriver and a snubby 2-3" phillips later. Also get a 1/4" socket set. First thing, go under the car and remove the heater hoses from the firewall and twist out the drain spiggot. Then go back inside the car. The heater core sits under the radio. Under the core is a tray used to catch the leaking antifreeze and drain it out the firewall. You need to remove this tray. It has 6-8 screws holding it. Once the screws are out it is tricky removing it with the center console in, but it can be done-twist and bend. Then remove the screws holding the core in place and pull out the heater core. One note on the replacement-got mine from Oreilly's for $20-the two lines coming out of the heater core swivel to line up with the holes through the firewall. If you don't swivel them it will never seem to fit. Then reverse the above order, fill up the fluid, bleed the air off and away you go. Took me about 3 hours total in a parking lot. Ruined a shirt, but got it done. You will also cuss being upside down under the dash. It's a small place for a 240 lb. guy :) This was for a 1993 Beretta. Expect some bloody knuckles and a few mental breakdowns.

Good luck, and rated the help!!!
REMOVAL & INSTALLATION CAUTION When draining the coolant, keep in mind that cats and dogs are attracted by ethylene glycol antifreeze, and are quite likely to drink any that is left in an uncovered container or in puddles on the ground. This will prove fatal in sufficient quantity. Always drain the coolant into a sealable container. Coolant should be reused unless it is contaminated or several years old.

For heater core removal on these vehicles, please refer to the procedure for vehicles with A/C.
1994-96 VEHICLES
See Figures 1, 2 and 3

  1. Properly disable the SIR system, as outlined earlier in this section.
  2. Disconnect the negative battery cable.
  3. Drain the cooling system into a suitable container.
  4. Raise and safely support the vehicle.
  5. Disconnect the drain tube from the heater case.
  6. Detach the heater hoses from the heater core.
  7. Carefully lower the vehicle.
  8. Remove the right and left sound insulators.
  9. Remove the steering column opening filler.
  10. Remove the floor air outlet duct.
  11. Remove the heater core cover.
  12. Unfasten the heater core mounting clamps, then remove the heater core from the vehicle.
How do I cange the heater core in my 1995 Chevy - bda4cf8.gif
Fig. 1: The heater core is located in the passenger's side footwell, below the glove compartment
How do I cange the heater core in my 1995 Chevy - d3686c3.gifsrc="/uploads/images/d3686c3.gif" alt="d3686c3.gif" class="h_mi" />
Fig. 2: Exploded view of the heater core and related cHow do I cange the heater core in my 1995 Chevy - 45d1f7c.gif1 of 2) - 1994-96 vehicles

45d1f7c.gif
Fig. 3: Component list for the heater core and related system components (2 of 2) - 1994-96 vehicles

To install:
  1. Position the heater core in the vehicle and secure with the mounting straps.
  2. Install the heater core cover.
  3. Install the floor air outlet duct.
  4. Install the right and left sound insulators.
  5. Install the steering column opening filler.
  6. Raise and safely support the vehicle.
  7. Connect the heater hoses to the heater core.
  8. Attach the drain tube to the heater case.
  9. Carefully lower the vehicle.
  10. Connect the negative battery cable.
  11. Enable the SIR system, as outlined earlier in this section.
  12. Connect the negative battery cable, then start the engine and check for coolant leaks. Check the coolant level, and add if necessary.
WWW.AUTOZONE.COM

Posted on Aug 11, 2009

Testimonial: "Thaks much yor directions helped alot. Thank You. LittleThunder128@comcast.net"

Ad

1 Suggested Answer

6ya6ya

6ya staff

  • 2 Answers

SOURCE:

Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Why does my 1995 chevy camaro not blow out hot air? i've changed the thermostat, it has a new radiator and hose, and new water pump. the heater core seems to be fine.


use your hand on both hoses into and out of the heater core to see that they are hot. if not the core is plugged and needs to be replaced. before you do that squeeze the hose upper and lower and the heater core hoses to make sure there is no air trapped in the system. be very very careful of the fan while you are doing this.

Nov 26, 2010 | 1995 Chevrolet Camaro

1 Answer

How do you replace a heater core in a 1995 chevy silverado?


well first how do you know its badd?? and its a hard job to do on almost every car out there but you will have to take apart some of your dashboard to get to it but if u cant see your self doing all that then just bypass the heater core until you can get it done by some one how can

Apr 26, 2010 | 1995 Chevrolet C1500

2 Answers

I HAVE A 95 JEEP GRAND CHEROKEE AND ALL I GET IS LUKEWARM AIR WE HAVE FLUSHED THE SYSTEM CHANGED THE THERMOSTAT, RADITOR CAP AND HOSE, WATER PUMP NO CANGE WHAT ELSE CAN I do?


If your gauge is showing correct operating temperature and you are getting no heat from the heater, check (just feel them) the hoses leading from under the hood through the firewall that service the heater. One should be uncomfortably hot, the other only warm. If they are pretty close to equal or even cool, you have an obstruction in the heater hoses. Rubber hoses in the cooling/heating system are made up of laminated layers and if aged enough, the inner lining can separate and collapse blocking the flow of water either to or from the heater core. Sometimes, if bad enough, squeezing the hoses by hand can even locate the failed section; it will be noticeably weaker than the rest.

Jan 13, 2010 | 1995 Jeep Grand Cherokee

1 Answer

1994 Chevy S10 Pick-up 4 cylinder, sloshing noise, no heat......is this a heater core problem?


no heat on this old of a vehicle definitly can indicate a heater core problem. sometimes flushing core with a hose can save heater core sometimes it will need replaced. make sure all coolant is properly disposed of if u flush core yourself

Nov 07, 2009 | 1995 Chevrolet S-10 CA Edition

1 Answer

Low coolant light on in 1996 chevy berretta


get a scan tool for that car i believe a tech 2 scanner will work adn clear the codes, if it comes back on then you are going to have to do some more digging

Apr 12, 2009 | 1996 Chevrolet Beretta

2 Answers

1998 chevrolet k-1500 heater-core replacement


Remove the heater hose clamps and the hoses from the engine side of the firewall. From the inside under the dash on the pass. side, remove the lower panel screws and slowly pry the lower cover down and the heater core will slide out of the heater box. Installation is reverse of removal.

Sep 20, 2008 | 1995 Chevrolet S-10 CA Edition

3 Answers

Heater core replacement


how can i replace a heater core on a 95 chevy blazer

Jul 29, 2008 | 1995 Chevrolet Blazer

1 Answer

1995 Chevy 1500 p/u heater core


nope pretty simple take off the heater hose clamps and the hoses from the engine side of the firewall. Under the dash on the pass. side, remove the lower panel screws pull cover down and the heater core should come out of heater box. reverse to reinstall

Jul 14, 2008 | 1995 Chevrolet C1500

Not finding what you are looking for?
1995 Chevrolet Beretta Logo

2,234 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chevrolet Experts

Marvin
Marvin

Level 3 Expert

85206 Answers

Jonah Oneal

Level 3 Expert

14092 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22484 Answers

Are you a Chevrolet Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...