KEY WONT TURN IGNITION

Tim, sounds like tumblers in ignition may be sticking or your keys cut worn out, put key in ignition and hit end of key sharply/some force with a small hammer, wrench, screw driver handle what ever you have, try turning key.
If this dose not do it call a good locksmith, they are cheape then the dealer.
"I hope this helped you out, if so let me know by pressing the helpful button. Check out some of my other posts if you need more tips and info."

Use a spare key if you have one, if not, have a locksmith cut you a new key, fresh cut key may work better.

A worn out ignition key can cause this problem too. Jiggle the key around in the cylinder and try to turn the key. If you have a spare key, try that because it might be less worn. Dealers can cut fresh keys if you have the VIN and can verify registration/ownership.

you need a new ignition, its a common problem ive done a few.hope this helps ( rate me thanks )

try turning the steering wheel hard both ways while jiggling the key (gently, you don't wanna snap it off) in the ignition. usually it just gets hung up on the steering wheel lock.
if that doesn't do it, try the same but with a spare key

Well you paid much more than you should have. Nexttime go to a salvage yard purchase you one and install it yourself.

check and move steering column jiggle that then put wd40 on key slide it in then jiggle the csteering wheel again sometimes it will stick

Sometimes you can jiggle the steering wheel left and right really hard while trying to turn the key. To change the ignition switch or tumblers you have to remove the steering wheel. Then remove the pressure plate and turn signal switch then you should see the ignition switch. There is usually a pin that you have to pull to release the switch. If I am missing a step it is due to my failing memory. Once you pull the steering wheel, just keep pulling until you get to the switch. Sorry for lack of instuction, I have fibromyalgia and can't remember much anymore. Hope this helps. Best wishes.

Could be.

Also the jiggling thing could be a coincidence. :0)

Tell me this.... when you turn the key, do you hear a CLICK?? If so your starter is probably bad.

:0)

you ignition locked up, take some wd-40 and spray it into the ignition hole, let it sit for 2 mins and do it again, then immediatly stick the key in and start working the ignition back and foirth.....

this will free up what ever is locked up....