SOURCE: Starter in a 1992 GMC Sonoma 4.3 v6
bottom rear of engine on the passenger side, the starter is serviced from under the car. it is held to the engine block with two bolts, then u must remove the battery cable and starter solenoid wiring as well, always disconnect the battery before doing any work on the starter.
SOURCE: what is the firing order on a 2000 4.3 gmc sonoma?
i dont know how they got it....i was just told that they got it......MEN!!!!
SOURCE: Starter problem on a '92 GMC Sonoma
u have to remove the flywheel housing, then it will drop down
SOURCE: Replacing heater core in 2000 GMC sonoma. Dash is
If the dash is removed you've saved about 9 10ths of the job endurance. Look around, what you believe to be, the perimeter of the heater box. I cannot, and no one else can, tell you exactly where the bolts and nuts that mount the heater box are. Therefore you must viually sixe the box and check outide in the engine compartment and inside under the dash for the mounting bolts.You'll want to start by removing the heater hoses. Then starting at the passenger side engine compartment look for a group of 10mm or 7/16ths nuts retaining the housing and remove them. Do the same inside. The housing is usually held together with screws or clips, it changes year to year. Keep a log or pix of the wires and cables and hoses(vacuum) that are connected to the housing for reassembly. You'll need to "roll" the box out from under the dash depending on how much of the dash has been removed. The core is easy to spot for is has two hoses sticking out, and, is encircled with clips or screws . Also make sure you remove the bracket around the two entry hoses if it has one. Thank you, Dana
SOURCE: I am replacing the heater core on a 2000 gmc
the entire dash assembly must be removed from the vehicle to change the heater core
108 views
Usually answered in minutes!
×