SOURCE: I HAVE A 2000 DODGE STRATUS 2.5 V6. WHERE IS THE
Cam is on the end of the block, crankshaft sensor is on the bottom of the block. Both are easy to change....are you changing these due to poor performance or no start condition?
SOURCE: replacing bad camshaft position sensor
Reverse procedure to install and prior to installing new sensor, lubricate sensor O-ring.
It is located under the water pump. Make sure when you remove the sensor that you rotate the crank shaft and look in the hole to make sure the pick up magnet is still in there. Sometimes they come loose and cause a no start or long crank. You will need to have the code cleared still.
SOURCE: 1996 Dodge Intrepid camshaft position sensor circuit malfunction
DO U UNDERSTAND THE MEANING OF "OUT OF PHASE"?? IT IS THE MECHANICAL TIMING OF THE SIGNAL FROM EACH SENSOR TO THE ENGINE CONTROL COMPUTER, WHAT IS THE CODE? ALSO TELL YOUR DAD (NICELY) THAT ATROUBLE CODE DOES NOT ALWAYS MEANS A FAILED SENSOR, ONLY A PROBLEM WITH THE SIGNAL, THAT CAN BE THE WIRING, IT CAN BE MECHANICAL OR IT CAN BE THE SENSOR, MANY POEPLE DON'T GET THAT AND SPEND TON'S OF MONEY CHASING CODES.I HAVE DONE THIS FOR 35 YEARS AND AM SURE OF WHAT I AM SAYING 100%
SOURCE: Where is the camshaft position sensor on a 2000 Ford Explorer?
in the rear like where the dist would normaly be
SOURCE: How to replace a 2000 Dodge Dakota Camshaft
it's the round plastic piece with a wire inside the distributor
1,453 views
Usually answered in minutes!
×