My old door was rusted, so I got a 2006 door from the junkyard and now nothing is working. Also all wiring seems to be off- as my horn sounds if I turn on the headlight. Harnesses plugged in perfectly.
Try plugging the harness in after rotating it 180 degrees, If not then the wiring was order/locations were changed from 03 to 06
here is 06 wiring charts https://images.search.yahoo.com/search/images;_ylt=AwrEzdxNKfVc9UUAPYhXNyoA;_ylu=X3oDMTEyajBycjRtBGNvbG8DYmYxBHBvcwMxBHZ0aWQDQTA2MDdfMQRzZWMDc2M-?p=2006+matrix+door+wiring&fr=cb-max
here is 03 wiring charts
https://images.search.yahoo.com/search/images;_ylt=AwrJ7JN9KfVcMRMAGSNXNyoA;_ylu=X3oDMTEyajBycjRtBGNvbG8DYmYxBHBvcwMxBHZ0aWQDQTA2MDdfMQRzZWMDc2M-?p=2003+matrix+door+wiring&fr=cb-max review them and print what you need
SOURCE: 2006 Toyota Camry....headlights will not come on;
there was a recall on the headlight switch up to 06 camrys,find out if your car is affected by calling Toyota with the chassis no,and month of build
SOURCE: 2003 Toyota Matrix won't start. No click when we
yes theres is, try locking and unlocking the pass/side door with the key. you can check for power at the starter at the small wire if theres power at that wire when the key is held in the crank position then you have a bad starter try taping on starter while key is held in start if its starts when tapping then starter is bad,heres a diagram to show you were to tap and where to check for power, hope this helps.
SOURCE: need wiring diagram for my 84 f250
your best bet is to purchase a Haynes manual it will have an in-depth wiring diagram for your truck. does any of your 12 volt items work? interior lights, lighter? Sounds more like a bad negative ground for your internal wiring harness or your fuse box itself
SOURCE: i need a wiring diagram for a 2006 BMW 325i
the connection at rear pass side was probably a battery switch installed from factory to turn main power on and off while vehicle sat on the lot it is a 2 pin connection also the other end is in the trunk beside the batterys ibs connection on the same harness, try disconnection the battery compleatly and touching the pos and neg terminals together for 15 to 20 min this is called a hard reset and possibly could solve this issue
SOURCE: 2003 Lincoln Town Car 1. Used
Try resetting these features, Deactivating/activating the horn chirp feature The horn chirp feature can be turned on/off through the following procedure: Complete steps 1-7 within 30 seconds or you must repeat the procedure. Wait 30 seconds before repeating the procedure. 1. Turn the ignition to the ON position. 2. Press the power door unlock control on the door panel 3 times. 3. Cycle the ignition from the ON to the OFF position. 4. Press the power door unlock control 3 times. 5. Turn the ignition to the ON position. The doors will lock and unlock. 6. Press the unlock control twice within 5 seconds. The horn will chirp twice to indicate a successful activation/deactivation of the horn chirp feature. To deactivate/reactivate the autolock feature using the power door unlock control You must complete steps 1-7 within 30 seconds or the procedure will have to be repeated. If the procedure needs to be repeated, you must wait 30 seconds. 1. Turn the ignition key to RUN. 2. Press the power door unlock control three times. 3. Turn the ignition key from RUN to OFF. 4. Press the power door unlock control three times. 5. Turn the ignition back to RUN. The horn will chirp. 6. Press the unlock control. The horn will chirp once to indicate the enabling/disabling of the autolock feature. 7. Turn the ignition to OFF. The horn will chirp once to confirm the procedure is complete. Pressing the power door unlock control again will toggle the Autolock/Relock states.
7. Turn the ignition to the OFF position.
Turn ignition to OFF to exit programming.
72 views
Usually answered in minutes!
×