The accent should be an hydrolic type, and what you are saying says to me the, clutch plate and cover is exstreamly worn and needs to be replased , ie bent toggels ext, but firstly make shore nothing is restricting the clutch pedal being depresed under the foot well
SOURCE: Clutch pedal low near floor, can the clutch be adjusted?
hi the clutch on accent is hydraulic operation so if pedal is very low on disengaging clutch ? you may have a problem with the hydraulics 1st thing to check is fluid level? this is the reservoir that feeds both brakes and clutch but is seperaterated inside if fluid low? top up and bleed the slave cyl however if fluid low indicates a leak ? possibly slave cyl? if no loss of fluid ? then prob may be fault in the master cyl ? check fluid come back with any update please ps if this problem has just occured? check for leaks ?
SOURCE: loud squealing noise when clutch pedal is depressed
sounds like its slipping on its way out me thinks
SOURCE: to change gears, I need to fully press down on my
Hi and welcome to FixYa,
In a manual 2001 Hyundai Accent, the clutch cable could be adjusted. The adjustment point is on the cable 'pad' where it enters the firewall in the engine compartment.
To adjust, the slack or free play must be decreased. This is done by turning the adjusting nut clockwise. Check back by pressing on the clutch pedal to your preference.
Good luck and thank you for using FixYa.
SOURCE: 2002 Hyundai Accent won't go into gear.
Probably the arm that holds the rtelease bearing in the bell housing has slipped out of place. Get someone to depress the clutch while you check the arm is not loose. If the cylinders are working then its most likely the arm is disconected. If you are lucky you may get it put back in place by looking through the inspection hole but most likely you will have to seperate the engine and gearbox. Sorry I havent better news for you.
SOURCE: 2001 hyundai accent clutch feels spongy and the
seems to be a worn clutch... Take/Tow your vehicle to an authorized Hyundai dealership and pay the diagnostic fee... they will tell you exactly what the problem is and the cost of parts/labor to fix it... at least this way you'll know what the problem is and what's required to fix it.
200 views
Usually answered in minutes!
×