Clear reading drove 150 miles did not reset with car. Cleared P1309 code when reset checkeng.light was out drove maybe 20 miles and checkeng.light came back on. This is stopping me from regeration willnot do smog check.will checkenglight is on.
SOURCE: check engine light
Had the same codes on my truck. cat converter was plugged. I was told to take the cat off and gut it, then put it back on and it would run fine, but that didn't work. You need a new cat. Might want to replace the o2 sensors before and after the cat also. Hope this helps.
SOURCE: I have a 2000 323i. We have error code P1520.
i would not try the crank sensor just yet first off they **** to replace properly and you wont want to do that just yet, make sure it is the same code that has come back on as far as the banks are concerned on that enging the m52 the front 3 cly are bank 1 and the back 3 are bank 2, so unless it is talking about O2 sensors that is irrelivant, are you sure you replaced the correct sensor? it is the on in front on the engine with NO wire tail on it make sure it is plugged in correctly, this car is VERY good at knowing the difference between a cam sensor and a crank sensor the other guy does not know what he is talking about
SOURCE: Check Engine Light - P2181
Hi,first thing your cambelt and tensioner should have been replaced 13k miles ago,it would pay you to replace the water pump at the same time as they are known for impellor failure = cooling system fault=P2181 code,hope this helps.
Darren
SOURCE: 98 Nissan Maxima - Check Engine Light, Knock Sensor
If the car is pinging you will set a knock sensor code.'
This comes from bad gas and running lean., You really need this professionally inspected to rule out the basics. I have seen alot of nissans with the knock sensor code stored but the light is still off.
Fill up the tank with high octane chevron and some techron injector cleaner and clear the light. If it stays off for a couple days then go get it inspected. Even if the code is stored it will still pass as long as the light is still off and the monitors have run.
SOURCE: Have 2000 Toyota Camry XLE. Check Engine light
What your asking, is how to make a malfunction light
go away from your dash, so you can forget you have a
problem & make no attempt to repair the car
Until you find & resolve active OBD2 Codes that actually set
a MIL or Check Lamp it will keep coming back
Every time you clear a code you have to run a drive cylce in
some cases to start the procees over, as you need those codes
to diagnose the issues
The codes that are there, do not tell you what to replace
Without writing a book here, just study OBD Systems online &
take the car to a repair shop
It is beyond your ability at this time to figure out
93 views
Usually answered in minutes!
×