Put the old trans module back in and check the large power feed wire at the fuse box on the center consul on the passenger side of the shifter consul,this is a known problem for having a poor electrical connector and will cause this problem. Wiggle this wire and you most likely will hear a relay click and the power steering message go out.
Try a global reset. Remove both battery cables and hold them together for 5-10 minutes. Hook back up and see if that takes care of the issue.
SOURCE: 2005 Chevy Cobalt
The replacement of the steering column assembly will require a setup procedure for complete repair. This is done via a tech 2 scanner. A good dealer technician should know this.
Eletronic Power Steering (EPS) is one of the latest ideas to eliminate the fluid type power steering systems. It eliminates the power steering pump thus adding miles per gallon.
SOURCE: Message: "POWER STEERING"
This is a major problem and I too have reported the issue to the National Highway Traffic Safety Administration. Please take the time and do the same. They can be contacted online at safercar.gov or BY PHONE: Call the Hotline, Monday-Friday 8am to 8pm at (888) 327-4236 , TTY:(800) 424-9153.
Sep 04, 2009
If you read and google you will find over 200 more complaints. This is an issue only GM/Chevy can fix. Report it to www.safercar.gov and the Department of Consumer Affairs. I have been battling this issue for 2 months.
SOURCE: power steering on chevy cobalt
i dont think you can just get the chip,its the complete power steering control module (
computer) typical problem withall ions and cobalts
SOURCE: 2005 chevy cobalt, car wont start ... check
disconecting the battery should reset the pcm. but you will need to find out what caused the problems.
1,025 views
Usually answered in minutes!
×