2006 Proton Savvy. Change headlight globe? - Proton Cars & Trucks

That sort of information is not available. If you want that, you would have to contact the factory, find the design team and get the archived technical drawings on that part.

Not sure how you think you are going to make one to spec, but you can just buy a new one.

https://www.google.com/search?q=gearbox+selector+spring+Proton+Savvy+1.2+manual

..

I thought to myself, "manual gear boxes don't have a neutral safety switch". The safety is that you have to use the clutch and the gear lever, whereas with an automatic, Park is your brake, if you are in Drive and the engine starts, the car will move forward due to the increased revs on start up. I have searched for 10 minutes using a few search queries and it bears out that one doesn't exist. No parts sold under 'proton savvy neutral safety solenoid' either.

https://www.google.com/search?q=%22proton+savvy%22+%22neutral+safety+switch%22+location

..

hi,
savvy engine is same with renault engine. there's a flywheel sensor/engine speed sensor between engine and gearbox. change the engine speed sensor.
The engine speed sensor is control the ignition timing, if the sensor can't read the 0' angle the engine won't fire up.

Check alt bat

proton savvy ...good little car but often wont start ...turns over , no start ...llock it ,eave it , come back will start . when doesnt , kick the clutch pedal in hard 2-3 times ...neutral start switch may be sticky .. put into neutral , depress clutch & brake ...then started !

Get it scanned for error codes. This car's ignition coil can give such problem. Don't change anything until you know the error code.

It is held by a spring with a hook that anchors to the inside of the side panel.

keep in mind, i found there was like a wire fixation of some sort over the bulb socket, so you have to unclip that first, if you have to do the passenger one first, i suggest you take a look at the drivers one and try to unclip that one as it makes it easier once you have an idea what the clip looks like and how you unclip it. :P

open the bonnet, locate a screw on top of the headlight and undo it, locate two screws between the centre grill and headlight and undo them and locate a screw right behind the headlight assembly and loosen it. Now the whole headlight should come out. It wont come all the way out. By unplugging the electrical plug you can take it out completely. Lift up the lock thats hold the rear headlight cover and that will expose the internals of the headlight and then you can change whatever globe you want. First disconnect the wiring plug from the globe and then release the clip holding the globe and replace the globe and make you sure you dont touch the glass part of the new globe which installing. Touching it will shorten the globes life and there is a chance that it might explode inside and create mess.

open the bonnet, locate a screw on top of the headlight and undo it, locate two screws between the centre grill and headlight and undo them and locate a screw right behind the headlight assembly and loosen it. Now the whole headlight should come out. It wont come all the way out. By unplugging the electrical plug you can take it out completely. Lift up the lock thats hold the rear headlight cover and that will expose the internals of the headlight and then you can change whatever globe you want. First disconnect the wiring plug from the globe and then release the clip holding the globe and replace the globe and make you sure you dont touch the glass part of the new globe which installing. Touching it will shorten the globes life and there is a chance that it might explode inside and create mess. You need to buy H7 type globe for low beam.