SOURCE: power door locks & dome lights dont work
hello first thing you need to check your fuses look for listing in your book under fuse panel then look for amperage of fuse it should be numbered in the book as well in the fuse box match the numbers same goes for your dome light goodluck
SOURCE: 2007 chrysler town and country interior dome lights
if it is covered by a white plastic then inspect it carefully and look for slots where you can put tiny screwdrivers to pry the plastics off, then you can replace your bulb. just be careful not to break the plastic.
tnx 4 using fixya,
drcool
SOURCE: Roof Dome lights fuse?
check your bulbs, and there should be another fuse box under your dash
SOURCE: 2002 Chrysler Town and Country
Ok, i'm assuming your replacing them, there is an oval rubber stopper on the backside of the rotor, in the backing plate, located near the bottom. it will tighten or loosen the e-brake shoes inside the rotor, loosen them all the way off, then get a big hammer and give them a really good smack, be carefull not to damage the wheel studs, if your reusing them hit on the hat of the rotor, if replacing you can hit right on the rotor face.
Use some antiseize on the hub before installin your new rotors, and don't forget to readjust your
e-brake and reinstall the rubber plug
SOURCE: On Chrysler Town and Country van keys were locked in the car and
does this van have factory theft device? if so you may have to reset to get the ramp working
57 views
Usually answered in minutes!
×