1993 Geo Prizm 1.6l 2 cams timing marks - Geo Cars & Trucks

SOURCE: 1996 geo prizm

you'll have to pull off the interior panel. window in the up position. on the lock cylinder there is a clip that you have to pull off and an arm that actuates the lock. pop the lock out. reverse to install.

SOURCE: cam timing

Firstly with this engine being identified as an interference engine, I will not accept any responsibility if your engine gets damaged. You are free to take or leave this advice and the responsibility will be entirely yours.

Engine codes: D2H, D6A, D6B, D6D, DDZ, DKZ, DFZ.
Covering years 1989 to 1997.

• Turn the crankshaft in a clockwise direction to about 10.00 o'clock on the mark on the camshaft sprocket. Good tip here, apply tippex to the sprocket mark.
• Now slowly continue to turn the crankshaft and with the timing pin feel for the locating hole behind the camshaft sprocket.
• You will find the camshaft location hole at about 8.00 o'clock.
• When you have located the the locating hole behind the camshaft sprocket, insert the timing pin.
• Now insert the timing pin in the crankshaft pulley.
• You will find the crankshaft pulley location hole behind the sprocket at about 10.30 o'clock.
• When both timing pins are in their locating holes, the top and bottom of the engine is in-line.
• This information is only to set the engine up and not to change the timing belt.
• I would advise that on these engines you change the timing belts at 60,000 miles or every 3 years which ever comes first. If for any reason the timing belt gets contaminated, change the timing belt.

SOURCE: 1994 GEO Prizm Fuel Guage

You need to replace your fuel sending unit. It is located inside of the gas tank.
Please remember to rate this solution.

SOURCE: 1993 Geo Prizm Lsi Harmonic Balancer

Yes a harmanic balancer from tha corolla is the same thing. I had to do the same thing with my 95 geo. It works out to be a lot cheaper buying for a toyota than a geo.

Harvey N Tawatao

• 3854 Answers
• Posted on Dec 23, 2009

SOURCE: geo prizm stereo radio wiring diagram

1994 Geo Car Stereo Wiring Schematic
Car Radio Battery Constant 12v+ Wire: White
Car Radio Accessory Switched 12v+ Wire: White/Black
Car Radio Ground Wire: Black
Car Radio Illumination Wire: Red/Yellow
Car Stereo Dimmer Wire: Red/Green
Car Stereo Antenna Trigger Wire: N/A
Car Stereo Amp Trigger Wire: N/A
Car Stereo Amplifier Location: N/A
Car Audio Front Speakers Size: N/A
Car Audio Front Speakers Location: N/A
Left Front Speaker Positive Wire (+): White
Left Front Speaker Negative Wire (-): Black/Blue
Right Front Speaker Positive Wire (+): Blue
Right Front Speaker Negative Wire (-): White/Red
Car Audio Rear Speakers Size: N/A
Car Audio Rear Speakers Location: N/A
Left Rear Speaker Positive Wire (+): Light Green
Left Rear Speaker Negative Wire (-): Light Green/Black
Right Rear Speaker Positive Wire (+): Gray
Right Rear Speaker Negative Wire (-): Gray/Black