I think you have a lot of room, look at what has to be removed, drain coolant, disconnect the hose remove fans, transmission lines they have o rings for leaking oil, use adjustable players to remove clamps, fill up coolant and let the air off by bleeder.
SOURCE: how to replace 2006 chevy colorado thermostat
find where top hose comes from the radiator into the engine block, then drain some of the coolant out and remove hose and thermostat from the block. remember which way the termostat sits in the block and install new one. its always a good idea to flush your cooling system before putting in a new thermostat. if the old one was plugged up, the gunk thats in your system will just plug up the new one in time too. you can get a bottle of radiator flush from most auto parts stores.
SOURCE: how do i change out the knock sensor on a 2006 chevy colorado
You didn't list your engine size so please pick the applicable to your motor size:
Removal & Installation
2.8L & 2.9L Engines
To Remove:
Knock sensor (KS) (A), Engine harness (B), Knock sensor (KS) connector (C)
To Install:
SOURCE: 2006 colorado intermittently fails to start. It
Clean all the electrical connections you can get to under the hood with automotive electronics cleaner,dry with compressed air and pack each connector with di-electric grease.
351 views
Usually answered in minutes!
×