SOURCE: turn signals wont work but flashers do
Hi.
On your 98 Dakota.
Is equipaded with a single Flasher.
If you replace all ready.
Check the FUSE # 10, 15 amp..
On the Fuse box. left side of Dash.
and the FUSE D 25, amp. On engine compartment Fuse box.
Check the proper funtion of the HAZARD switch.
Bacause if the Hazard switch is bad the turn signal don't will work. Match the OLD flasher with the New one.
If after of this still not work.
Remove the steering wheel cover, locate the Turn signal switch connector and with a TEST Light check power with the Key ON
12v. to the RED wire and PINK wire..
If you found 12v. check the connection with the switch.
If the connection is good. you will need to replace the turn signal switch.
But if you don't found 12v. You need to look a an open circuit.
And fix it..
I hope this help on your problem..
Thank you for use fixya...
SOURCE: install wairing diagram volkswagen beetle build in 1974
you need to buy your self a good repair manual such as Bentley repair, good luck and please rate -Jeff
http://www.autopartswarehouse.com/details/QQVolkswagenQQBeetleQQBentleyQQPaper_Repair_ManualQQ19701979QQW0133-1623686.html
SOURCE: Where do I install the electronic flasher relay for the turn signals?
If the turn lights come on and don't flash, like mine did, I found the flasher behind the ashtray.If you can't reach it,there are only 4 screws holding the bracket (1/4 in.nut driver) that holds the ashtray.
SOURCE: no turn signals but flashers work
You may have two relays one for hazards and one for turn indicators.
773 views
Usually answered in minutes!
×