Changed fuel pump and filter.no change.runs great for 15-20 minutes, then misfires again.
SOURCE: 99 4runner 5vz-fe 3.4 misfire
I know this post is old, but right on the engine theres a sticker that says use multi-ground plugs only. I read a similar problem like yours and it seemed to turn out that the spark was arcing to ground over the ceramic on the plug. So maybe it could have something to do with the single ground plugs.
SOURCE: 2001 Firebird 3.8 misfires
Check your alternator see if you have a drop in voltage on your tack,then it is the problem.I too was a victim of high price tune up and still had a problem with a misfire.and cover your coil pack with a piece of rubber water run of onto your power pack .Another thing is to use a silicone spray on all wires.
SOURCE: 03 Jeep Liberty random misfire
try checking your ignition coils and also the power wires to them!!Hopefully this helps....
SOURCE: PO300 Error code Random/Multiple Cylinder Misfire Detected
change the coils but most likely a bad ecu
SOURCE: 2000 civic 1.6. Multiple misfire, random
Hi there:
A code P0300 may mean that one or more of the following has happened:
Faulty spark plugs or wires
Faulty coil (pack)Faulty oxygen sensor(s)Faulty fuel injector(s)Burned exhaust valveFaulty catalytic converter(s)Stuck/blocked EGR valve / passagesFaulty camshaft position sensorDefective computer
Possible Solutions: If there are no symptoms, the simplest thing to do is to reset the code and see if it comes back.
If there are symptoms such as the engine is stumbling or hesitating, check all wiring and connectors that lead to the cylinders (i.e. spark plugs). Depending on how long the ignition components have been in the car, it may be a good idea to replace them as part of your regular maintenance schedule. I would suggest spark plugs, spark plug wires, distributor cap, and rotor (if applicable). Otherwise, check the coils (a.k.a. coil packs). In some cases, the catalytic converter has gone bad.
If you smell rotten eggs in the exhaust, your cat converter needs to be replaced. I've also heard in other cases the problems were faulty fuel injectors.
Random misfires that jump around from one cylinder to another (read: P030x codes) also will set a P0300 code. The underlying cause is often a lean fuel condition, which may be due to a vacuum leak in the intake manifold or unmetered air getting past the airflow sensor, or an EGR valve that is stuck open.
Hope this helps.
197 views
Usually answered in minutes!
×