SOURCE: torque specifications for 1998 ford ranger
Okay...here is a list since no motor size:
2.5L----- 56-64
3.0L----- 56-64
4.0L----- 59
5.0L----- 75-85
All in ft lbs.......this is for the flywheel.
SOURCE: Ineed a timing diagram for 1995 1.9 ford escort
both the cam gear and the crank gear timing marks should point straight up. if you are replacing your timing belt you may also want to replace your timing belt tensioner and water pump. I have owned several escorts and have learned the hard way that it is a good idea to replace all of these at the same time.
SOURCE: Escort Mk2 1600 valve and torques settings what are they
cylinder bolt torque settings stage 1 15 ft pounds
stage 2 50 ft pounds
stage 3 85 ft pounds
valve clearences 0.15 - 0.20mm inlet
0.22 - 0.27mm exhaust
these are the figures i have been supplied with, you can also use
cylinder bolts stage 1 10 ft pounds
stage 2 50 ft pounds
stage 3 + 90deg.
with my exp, i would use the first guide as the degree method has a tendancy to snap head bolts, especially on older vehicles.
SOURCE: how to install a coolant temp sensor in a 1995 ford escort
The coolant temperature switch and fan control switch are located sie by side, mounted in the steel portion of the heater hose that runs from the thermostat housing to the firewall, it is underneath the air intake tube and the ignition coil pack, mounted to the back of the cylinder head. Either drain out some coolant or be very quick, and you can unplug and unscrew each switch from the hose and replace it with a new one. Make sure the engine is cold. After replacing make sure to check the coolant level add as neccessary. The single wire connector switch is for the guage, and the other is for fan control. Hope this helps, let me know.
106 views
Usually answered in minutes!
×