Need a 1995 plymouth grand voyager window switch wire diagram

SOURCE: wire diagram 1999 plymoth grand voyager

What section are you needing?

Marvin

• 85242 Answers
• Posted on Jul 05, 2009

SOURCE: 94' plymouth voyager care stereo wiring diagram needed

1994 Plymouth Voyager Car Radio Stereo Wiring Diagram
Car Radio Battery Constant 12v+ Wire: Red/Black
Car Radio Accessory Switched 12v+ Wire: Red/White
Car Radio Ground Wire: Strap or Chassis
Car Radio Illumination Wire: Black/Yellow
Car Stereo Dimmer Wire: N/A
Car Stereo Antenna Trigger: Yellow
Car Stereo Amp Trigger Wire: N/A
Car Stereo Amplifier Location: N/A
Car Audio Front Speakers Size: N/A
Car Audio Front Speakers Location: N/A
Left Front Speaker Positive Wire (+): Dark Green
Left Front Speaker Negative Wire (-): Dark Green/Red
Right Front Speaker Positive Wire (+): Violet
Right Front Speaker Negative Wire (-): Violet/Yellow
Car Audio Rear Speakers Size: N/A
Car Audio Rear Speakers Location: N/A
Left Rear Speaker Positive Wire (+): Brown/Yellow
Left Rear Speaker Negative Wire (-): Brown/Light Yellow
Right Rear Speaker Positive Wire (+): Dark Blue/White
Right Rear Speaker Negative Wire (-): Dark Blue/Orange

SOURCE: Need a diagram for a 1992 Plymouth Grand Voyager

Here's a link to both size motor diagrams...

V6 3.0L
http://www.gates.com/common/part_locator/view_diagram.cfm?id=S4001

V6 3.3L
http://www.gates.com/common/part_locator/view_diagram.cfm?id=S7006

If this helps, please post feedback. Thanks

SOURCE: Needed serpentine belt diagram for a 91 ply. voyager 3.3L engine

Here's a link to the diagram you need...

http://www.gates.com/common/part_locator/view_diagram.cfm?id=S7006

Good luck and please rate this solution. Thanks.

Testimonial: "Looks good."

SOURCE: 1996 Plymouth grand voyager se-need diagram

The BCM is located on the drivers side under the the steering column. It is behind the fuses and to get to it you have to remove the bash board plastic, than a pice of metal and than you have to remove the fuses box. It will take you approximately 20 min to remove everything. Once you remove the BCM you need to take note of the Part Number P/N. It has to be the same P/N on the replacement BCM. You can use any BCM from years 1996-2000 but make sure the electrical configuration is the same as yours (Power windows, alarms, etc.). I bought my BCM on the junk yard for 35 dollars and my car works perfectly.
I hope this may have assisted you,
Tom