Question about 2000 Dodge Neon

1 Answer

I have a 2000 doge neon i had the batry changed now you trun key it wont start every thing comes on but wont start

Posted by on

Ad

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

  • Dodge Master
  • 1,724 Answers
Ad

6 Suggested Answers

6ya6ya

6ya staff

  • 2 Answers

SOURCE:

Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017

Ad

Charlie

  • 280 Answers

SOURCE: 2002 doge neon r/t revs itself when i start it

The most common source of that problem is a sticking idle control motor. As a first step, purchase a new gasket and/or O-ring for the idle control motor. Remove the motor and clean it out using aerosol carburetor cleaner. If the idle control motor was sticking, that should cure it. It the fix only lasts temporarily, you need to replace the idle control motor. This is a common problem with vehicles with over 80,000 miles on them.
Charlie

Posted on Jun 18, 2009

Anonymous

  • 5 Answers

SOURCE: 2002 doge neon r/t cant find idle control motor

back side of the throttle body under air cleaner. but if you put a new one on. it will rase up at first the idle down after about a min. then take it down the road at 40 mph. should be OK then. don't forget to use carb cleaner on the port where you take it off from. good luck

Posted on Jun 20, 2009

Franco2112

  • 76 Answers

SOURCE: my 2000 vw will not trun over or come out of park

Extra key/keys not programmed to the car. must see dealer to fix. Bring all other keys (valet included) to be reprogrammed.

Posted on Jul 27, 2009

Anonymous

  • 490 Answers

SOURCE: I have a 2000 Dodge Neon and wount start.I checked

I dont remember but sounds like you are having a problem with a netural safety switch it's located on the top of the transmission it should have several wires going to it,probably 4 to 6 wires.Just a thought.I could be wrong.but it's free hope you can use this.

Posted on Aug 25, 2009

jason jackson

  • 395 Answers

SOURCE: 2003 DOGE NEON IGNITION .LIGHTS, POWER COMES ON

replace the ignition switch
The ignition switch is usually mounted to the steering column and is operated by a linkage rod.
NOTE On column-mounted ignition switches, don't confuse the switch with the lock cylinder and keys. The ignition switch is not normally visible. On some vehicles, the steering column support has to be removed and the column lowered to find the ignition switch. On others, the switch is accessible under the dash.
f32-17gif.gif The ignition switch is operated by the key switch. Courtesy of Ford Motor Company. To replace the switch:

  • Remove the ignition switch wiring harness.
  • Unbolt it from its position.
  • Bolt the new switch into position.
  • Attach the witing harness.

Posted on May 23, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Someone attempted to steal my doge neon 2002. Now the kill switch is preventing the car from starting. What do I do?


RE: Someone attempted to steal my doge neon 2002. Now the kill switch is preventing the car from starting. What do I do?Posted by Calliean... on Oct 18, 2014 ..


Disconect the Battery for 20 Minutes it will reset the computer

Oct 18, 2014 | 2002 Dodge Neon

2 Answers

Eletrical problems


if you take out the instrument cluster,you will find that it has a double sided pc board. the connector will have broken solder joints on the inside of the pc board,so it has to be removed from the cluster housing to see it.resolder the pins and it will be fine.I have seen 50 of those

Jul 25, 2010 | 1995 Dodge Neon

1 Answer

2003 DOGE NEON IGNITION .LIGHTS, POWER COMES ON BUT CAR WILL NOT START AFTER I PLAY WITH IGNITION SEVERVAL TURING AND PUSHING IT IN SEVERAL TIMES IT THEN STARTS


replace the ignition switch
The ignition switch is usually mounted to the steering column and is operated by a linkage rod.
NOTE On column-mounted ignition switches, don't confuse the switch with the lock cylinder and keys. The ignition switch is not normally visible. On some vehicles, the steering column support has to be removed and the column lowered to find the ignition switch. On others, the switch is accessible under the dash.
f32-17gif.gif The ignition switch is operated by the key switch. Courtesy of Ford Motor Company. To replace the switch:
  • Remove the ignition switch wiring harness.
  • Unbolt it from its position.
  • Bolt the new switch into position.
  • Attach the witing harness.

May 22, 2010 | 2003 Dodge Neon

1 Answer

2ooo plymouth neon wont start it just clicks twice rplaced battery, park neutral switch and tested starter please help


Could be the ignition switch is worn out. Not the key part but the electrical part connected to the key. It has wires coming out of it.

Nov 07, 2009 | 2000 Plymouth Neon

1 Answer

Can't find the crank sesnor on doge neon where could I find it


Look on engine block, behind alternator, just above oil filter.

Aug 30, 2009 | 2000 Dodge Neon

1 Answer

I have a 2000 Dodge Neon and wount start.I checked starter, battery, cables and just changed the key cylinder. When I try to turn the key it feels like its not catching anything and I do have power but it...


I dont remember but sounds like you are having a problem with a netural safety switch it's located on the top of the transmission it should have several wires going to it,probably 4 to 6 wires.Just a thought.I could be wrong.but it's free hope you can use this.

Aug 25, 2009 | 2000 Dodge Neon

1 Answer

I HAVE A 2000 DODGE NEON I JUST BOUGHT WITH NO KEYS . I TOOK OUT THE IGNITION AND GOT A USED ONE FROM A INTREPID WITH THE IMMOBILIZER I GUESS ITS CALLED I CANT GET IT TO START THE CAR THE KEY TURNS AND...


if you turned the key with the ignition with the imobilizer, you now have to get the right ignition and a new PCM because the PCM now thinks the car has SKIM (imobilizer)

Jun 24, 2009 | 2000 Dodge Neon

1 Answer

Flashing light in gauges


security system . Trun the ignition key on and leave it on for about twenty minutes,(light should stop falshing) then try and start it.

May 20, 2009 | 2000 Pontiac Sunfire

Not finding what you are looking for?
2000 Dodge Neon Logo

Related Topics:

26 people viewed this question

Ask a Question

Usually answered in minutes!

Top Dodge Experts

Marvin
Marvin

Level 3 Expert

85222 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22485 Answers

Jonah Oneal

Level 3 Expert

14092 Answers

Are you a Dodge Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...