SOURCE: 04 dodge ram 1500 HEMI's new brake pads won't fit
what you need to do is line clamp brake hose so you dont push dirty brake fluid back into your system..(you can use a pair of needle nose visegrips if you dont own an actual line clamp) loosen bleeder at this point, remove caliper from attatching bracket, with old pad still installed next to piston use a big C-clamp to compress piston, just make sure clamp is centered and compress slowly allowing brake fluid to escape through loosened bleeder... once compressed tighten bleeder and install caliper and pads remove lineclamp....******NOTE******* no need to bleed the system cause of lineclamp procedure... Make sure upon reassembly you use plenty of brake lube on all sliding caliper parts...Good Luck
SOURCE: 04 dodgebram 1500 hemi stalls some times
Check the throttle body---if it is very dirty it causes the air flow to change and causes stalling --cleaned mine and no problems / also change PCV valve go to hemitruckclub.com and lots of tips and fixes..........
SOURCE: Truck stalls while driving down the road.....
SORRY but you have a very typical dodge problem.dodges are VERY well known for these little and big wiring problems.you can find an electrical expert thats highly recomended or the dealer.if you don't fix it well,my grandads had some small problems fuel hand radio insturment panel would all stop working some times and some times work fine,then one day it burned the whole harness inside truck and under hood then it really cost a pretty penny.hope you get her fixed..
SOURCE: 2007 dodge Ram 1500 hemi fuel cap sensor comes on
I just had the same problem, new cap, deleted the codes with a obd... took it to the dealership...
its the EGR valve that was bad on my truck 2007 dodge ram 45000 miles...
i get it back on friday, its a simple part 1 wire harness and 2 bolts and gasket.
290 views
Usually answered in minutes!
×