2005 Chevy colorado remove camshaft sensor - 2005 Chevrolet Colorado

SOURCE: 2005 chevy colorado runs rough and gets bad gas mileage.

Sounds like it needs spark plugs and wires, and a fuel system treatment.

SOURCE: Where is the camshaft position sensor located-99 Chevy Lumina 3.1

It's held down by one bolt right above the timing chain cover. It's next to the head that's facing toward the front of the car.

SOURCE: locate camshaft sensor 2002 chevy trailblazer

Assuming you have a 4.2L engine here is the location.


Hope this helps out,
if so please rate my answers.
Brett

SOURCE: 2005 chevy colorado abs fault

Sounds like water getting in one of the connectors. You will need to see what fault code is in there when the light comes on, then look at that sensor.

Greg Bernett

• 2993 Answers
• Posted on Sep 03, 2009

SOURCE: how do i change out the knock sensor on a 2006 chevy colorado

You didn't list your engine size so please pick the applicable to your motor size:

Removal & Installation 2.8L & 2.9L Engines To Remove:

1. Lift the vehicle high enough to gain access to the knock sensor (KS) through the left front wheelhouse.
2. Remove the left front wheel and wheelhouse liner.

1. Disconnect the knock sensor (KS) connector.
2. Detach the knock sensor (KS) from the engine block.

1. Attach the knock sensor (KS) to the engine block.
   • Tighten the bolt to 18 ft lbs (25 Nm).
2. Connect the knock sensor (KS) connector.
3. Install the left front wheelhouse liner and wheel.
4. Fully lower the vehicle.