My wipers don't work on 1994 oldsmobile cutlass ciera is it the fuse or motor gone out

SOURCE: The windows in the 95 oldsmobile cutlass ciera won't work at all

maybe the wire is severed where the door (drver dr) pivots. thats what was wrong with mine. there is a rubber boot with crinkles in it that hold all the wires together. you can also try replacing the switch board that controls the wndws on the drvr dr. hope that helps.

SOURCE: Changing spark plugs on a 1995 Oldsmobile Cutlass Ciera

ALL YOU NEED IS 3/8 RATCHET WITH A 5/8 SPARK PLUG SOCKET.YOU NEED EXTENSIONS AND UNIVERSAL JOINTS TO GET TO HARD TO REACH PLACES.YOU NEED A SPARK PLUG GAUGE.YOUR SPARK PLUG GAP SETTING WILL BE. 0.060 THAT WILL BE FOR THE 2.2 AND 3.1 ENGINES.

Testimonial: "Thank you very much for your advice and time!"

SOURCE: how do I remove the windshield wiper arm from a

most car parts stores will do it for you and you can watch

SOURCE: 1994 oldsmobile cutlass supreme sl the fuse box for signal lights

the fuse box will be in 1 of 3 places (1)glovebox (2)under dash by drivers foot kick panel or (3) under hood .

SOURCE: cant locate hazard flasher relay on my 1994 oldsmobile

ok i have found your answer but i found it on another website so i copied it for you to rummage thru I hope this is what u were seeking and glad to help.

flasher switch location The flasher switch for the 94 cutlass is not where you would think it would be it is behind and off to the side of the ashtray or below the radio.

New Answer Headline The above is accurate; getting to it is a little tricky. Open the glove box and remove the tether wire connection at the door by unscrewing the SHC screw with a T-15 Torx driver. This will expose 2 of the 4 fuse panel mounting screws. Use an 8mm socket to remove all four and wiggle the panel out. The flasher is behind and to the left in the harness itself, not on a terminal block. Use a straight blade screwdriver to gently pry the two prong connection from the unit (Mine was an OEM Wagner - bright yellow.)
Additional Answer
It depends if you're talking about the turn signal flasher or the emergency flasher. The emergency flasher is directly behind the glovebox. If you're referring to the turn signal flasher, I just replaced mine last night without having to mess with the fusebox or glovebox. It turns out that it was attached by a clip on the right side of the ashtray frame inside the dashboard. I took out the removable "cup" part of the ashtray, then removed the two upper and two lower ashtray frame screws. Next, I pulled the frame forward and disconnected the small ashtray light. The power wire for the cigarette lighter can stay attached. After I slide the frame out the rest of the way it was easy to get to and replace the flasher unit.