Check engine light on
ABS system get it scanned.
Hello
u'd need a proper manual for this in my opinion
like there are plenty of dealers and online shops that deal in those..
you can get some free at reliable-store and it;s actually really illustrative
SOURCE: check engine light code p1603
When I went outside to start my Jaguar X-Type it was cold outside. I was in a hurry and didn't let the car warm up properly. It jumped a bit then the check engine light came on along with a message that said No cruise control. The no cruise light came off but my check engine light is still on. Any suggestions as to what it may be?
SOURCE: how do i fix code po420 & po430 on 2003 jaguar
Both these codes relate to Catalyst efficiency below threshold on banks 1+2. This is normally caused by a combustion fault. This fault may be shown due to a faulty sensor in either air imput or exhaust systems, Get the memory read at a dealers or good garage. If you had a serious problem the car would not drive well.
Hope this helps - good luck.
SOURCE: x-type jaguar automatic (gear box fault)
I have a 2002 X type (2 litre. done 44000 miles), dash showed gear box problem, (red circle light up). I pulled out and turned the engine off. 5 minutes later turned the engine on. The engine running but the car would not drive either in drive or reverse. Turned the engine off again and on the car driving but not much power. The care is taken to the Jag. dealer and told is misfiring + some gear box faults. Suggesting to change some coils and see (cost about £200+). also possible need to change the gear box costing about £2500+. Please advice. Shall I go ahead with the repair? Should I part exchange.
SOURCE: 2003 Jaguar S Type R 4.2L SC. Check engine light
Rent a scanner, read out any code(s), and pursue to repairs. It may be as simple as bad spark plugs and wiring, or worse, fuel problems from the injectors back to the fuel tank. A worn O2 sensor can cause improper fuel/air problems.
SOURCE: 2005 Jaguar X-type p1796, p1797 fault codes -
both of these codes refer to the transmission,it is now in LIMP HOME MODE,the codes refer to open or shorted circuits in the CAN (controlled area network) the computer system in the car. check for blown fuses first,then have the car scanned with a european scan tool which is capable of bi-directional communication with the vehicle,get back to me if you need more help,Please rate my fix as i strive to be the best Thanks Ray
60 views
Usually answered in minutes!
×